demicobra
Fri August 20, 2004 3:30am
|
Cross Drilled & Slotted Rear Rotor
|
|
fastimes
Wed September 22, 2004 5:55pm
|
DSCN0144
I have installed new msd cap wires rotor since this photo
|
|
demicobra
Wed November 10, 2004 7:42pm
|
|
Secret Squirrel
Tue December 21, 2004 8:02am
Rating: 10
|
Rear Wheel Well
Checked all nuts and bolts in rear wheel well area for tightness & check rear dust plate for clearance against rotor prior to road test, 12/18/2004.
|
|
Secret Squirrel
Tue December 21, 2004 8:06am
Rating: 10
|
Front Wheel Well
Checked all nuts and bolts in front wheel well area for tightness prior to road test, wheels temporarily aligned with measuring tape method, 12/18/2004.
|
|
bshap
Thu April 21, 2005 4:03am
Rating: 8
|
Estate sale
Here is a beautiful NEARLY NEW 1983 Cobra. Properly and carefully built from a WEST COAST COBRA kit, it is fitted with a Ford 460ci V8 engine. This beast has only gone approximately 8000 miles since completion. Always stored inside. The builder/collector/owner recently passed away and this is an estate sale. It has a Nascar Can-Am chassis with power rack and pinion steering; 11-inch vented rotors with 4-piston racing calipers; 4-bar rear axle with 9-inch drop-out center section; 25 gallon race-legal fuel cell; weight 2970lbs (50/50 front/rear). Available with or without a spare fully-rebuilt 460ci engine. Located near Toronto Canada. Pre-purchase inspections and/or appraisals are welcome. Hard to find a nicer example! Asking cdn$56,000.00 (us$45,000) OBO Contact Bob Shapton 519-927-3966
|
|
Tongue Pirate
Mon August 8, 2005 10:42am
|
Slight Wear
Belive it or not these guys actually do restorations in their free time. They complianed of brake noise on the company truck.
|
|
66rdster
Mon September 26, 2005 5:14pm
|
|
Engineer Ed
Sun October 2, 2005 6:17pm
|
What's wrong with this picture?
Broken rotors during track event / Gainesville 2005.
Now that is super braking power!
|
|
mickmate
Wed October 25, 2006 7:44pm
Rating: 10
|
Laser cut rotor hats
Programmed and laser cut these to fit my 6 pin to Wilwood rotors
|
|
mickmate
Wed October 25, 2006 7:44pm
Rating: 10
|
Laser cut rotor hats
Programmed and laser cut these to fit my 6 pin to Wilwood rotors
|
|
auscobra
Sun November 19, 2006 9:26pm
Rating: 10
|
front left rotor
rotor and brake in place
|
|
demicobra
Wed February 21, 2007 1:15am
|
330mm Rotor & Polished Caliper
|
|
slow_motion
Wed March 28, 2007 11:55am
|
DSC_0647
installing the rotors and calipers
|
|
52chevyred
Mon June 25, 2007 6:15pm
Rating: 10
|
Strange_posi_Medium_
Strange 9" 3.25 posi and 11" rotor
|
|
