kitcarbp
Fri March 6, 2009 7:29am
Rating: 9
|
Ford_Raditor_Heat_Rejection_Chart- Street Rod Example
This chart compares the heat rejection rate (cooling capacity) of three different types of radiators tested on an old Ford Street Rod. Coolant flow rate is held constant at 7 gpm (typical flow at idle perhaps, not sure where its being measured ???). It graphs the heat rejection for each radiator versus air flow through the radiator core. It is comparing 3 diff rad designs/materials at different CFMs through the core. The more air flow you have for a given coolant flow rate (7 gpm in this example) , the higher the heat rejection, basically linear in this example. The author of this graph is most likely selling the high efficiency radiator showing the improvement over the other two designs. To sum it up, the radiator at the top of the chart appears to be the most efficient at a low coolant flow rate (7 gal/min) over all air flows tested. Ya see how important rad core/tank design is? I learned something here.
|
|
Plums
Sun March 15, 2009 5:41am
|
Emily showing off my new plates.
Bolting the plates on and stuff falling out of the sidepipes....
|
|
Tommy
Sun April 5, 2009 9:16am
Rating: 10
|
EM Throttle cable linkage
EM Cobra showing throttle cable and connection to Holley carb
|
|
Tommy
Sun April 5, 2009 9:16am
Rating: 10
|
EM Throttle cable linkage
EM Cobra showing throttle cable and connection to Holley carb
|
|
DocDirk
Wed April 8, 2009 8:38pm
|
Right rear lower link arm at axle
Rotated view of rear lower link arm right side showing square link arm attached inside a square receptacle on the axle...very little or no room for rotaion with axle movement.
|
|
martrogers
Tue July 21, 2009 2:02am
|
rear showing aerial position
|
|
Pete Munroe
Wed July 22, 2009 10:12pm
|
ERA FIA Canton oil thermostat, top view
oil thermostat from the top showing some of the hose runs
|
|
RedSnake351
Fri July 24, 2009 9:52pm
|
RC and Red
Arcie showing his Mating Call!
|
|
CoupedUp
Sun August 9, 2009 8:05pm
Rating: 10
|
John Force All Ford Show
My little detailer showing off the fruits of his labor!
|
|
SunDude
Tue August 25, 2009 9:41am
Rating: 10
|
Showing the Cobra at the antique car show, Upper Canada Village, Morrisburg
|
|
mdross1
Sat August 29, 2009 5:46am
Rating: 10
|
mdross
Showing Harwood scoop to clear air cleaner capable of feeding 460ci
|
|
martrogers
Fri October 2, 2009 11:59pm
|
ackit
Pic showing the drilling template with 2 holes drilled. In the background is a template I made by putting cling film on the bonnet, and getting the curve into body filler. This mould template was then used to ensure the AC would fit the curve of the bonnet.
|
|
eschaider
Mon October 5, 2009 10:53pm
|
Oil System Remote Filter
Filter side of remote showing NASCAR sized WIX Filter mount
|
|
fkemmerer
Thu October 8, 2009 10:31pm
|
Oil Thermostat - Drivers Side 1
Completed installation of a Canton Oil Thermostat on an ERA 427SC showing lines and mounting location.
|
|
fkemmerer
Thu October 8, 2009 10:31pm
|
Oil Thermostat - Top down under the hood
Completed installation of a Canton Oil Thermostat on an ERA 427SC showing lines and mounting location.
|
|
