STEVE POTTS
Mon April 9, 2007 6:53pm
Rating: 10
|
9" ford stainless steel rear end housing
Knock off hubs w/ wilwood brakes attached
|
|
fastraxsg
Sun April 29, 2007 8:17pm
|
tow bar
Attaches to existing hole in middle of Torana front end, has welded vertical leg at rear to catch edge of crossmember. Drilled hole in front to attach clevis to.
|
|
1985 CCX
Tue May 8, 2007 7:04pm
Rating: 10
|
Roll bar mounting in trunk
Preparing frame attachment in trunk.
|
|
scales
Tue August 7, 2007 7:17pm
Rating: 10
|
|
fkemmerer
Sat September 1, 2007 8:19pm
|
Polished Aluminum for ERA
I have decided to polish all of the visible aluminum panels for my ERA 427SC Cobra. Attached are a set of photos which show the results of my efforts. Thanks to Ron Randall for explaining the process to professionally polish sheet aluminum. I'd say his approach is a good one!
|
|
fkemmerer
Sat September 1, 2007 8:19pm
|
Polished Aluminum for ERA
I have decided to polish all of the visible aluminum panels for my ERA 427SC Cobra. Attached are a set of photos which show the results of my efforts. Thanks to Ron Randall for explaining the process to professionally polish sheet aluminum. I'd say his approach is a good one!
|
|
fkemmerer
Sat September 1, 2007 8:21pm
Rating: 10
|
ERA 753 - Chassis
The attached is a picture of the chassis for my ERA 427 SC Cobra. It is ERA #753
|
|
mickmate
Mon October 15, 2007 8:02pm
|
Roll bar install CCX
Shows the brackets on Jeffs car where the outside and inside hoop legs and rear brace attach to the frame.
|
|
mickmate
Mon October 15, 2007 8:02pm
|
Roll bar install CCX
Shows the brackets on Jeffs car where the outside and inside hoop legs and rear brace attach to the frame.
|
|
mickmate
Mon October 15, 2007 8:02pm
|
Roll bar install CCX
Shows the brackets on Jeffs car where the outside and inside hoop legs and rear brace attach to the frame.
|
|
mickmate
Mon October 15, 2007 8:02pm
|
Roll bar install CCX
Shows the brackets on Jeffs car where the outside and inside hoop legs and rear brace attach to the frame.
|
|
cobrajam
Sun November 18, 2007 5:45pm
|
FE Quick Time Bellhousing
comes complete with aluminum block plate, 2 different fork mounts, 3 different diameter trans rings, all attaching hardware
|
|
TWOOD
Sun February 24, 2008 10:04am
Rating: 10
|
wiring routed along frame
I attached the wiring (inside the convoluted sleeving) to the brake and fuel lines with cable ties
|
|
cobrajam
Mon March 3, 2008 8:14pm
|
Midstates4ptRB_Small_
Midstates 4pt Roll Bar, 2 inch o/d, attaches to frame at all 4 points
|
|
TWOOD
Fri March 14, 2008 4:29pm
|
DOOR LATCH RELEASE LINKAGE
View at top end of lionkage with the 1/4" dia. shaft passing through the bronze bushing (epoxied to fiberglass). Lever is attached to end of shaft. Hole in shaft is threaded and has nylock jam nuts on each side.
|
|
