klayfish
Mon April 15, 2002 6:54am
Rating: 10
|
|
ronzara
Sat May 25, 2002 1:38pm
|
Lokar Shifter
My Lokar Shifter installed. Notice Doors hung.
|
|
Naja
Sat August 17, 2002 11:11am
|
Yours Truly
Measuring to fit the tail lights properly. Notice the clear lens to more closely match the (ultimate) white paint. (I had to slightly modify the tail lights to pass inspection, but I think I still preserved the 'clear' effect).
|
|
Rick Parker
Wed December 25, 2002 10:49pm
Rating: 10
|
Lower Fabricated cooling "hose"
Notice the small air bleed hole to purge any air from system after filling.
|
|
Rick Parker
Wed December 25, 2002 10:54pm
Rating: 10
|
Left Engine & suspension
Notice the removable air bleed in uppermost part of radiator, to eliminate air after filling.
|
|
John Poling
Mon March 17, 2003 6:45am
Rating: 10
|
Some Color
Completed doors in 1997 Toyota (Ouch) Red. Notice background is the body with the basecoat silver sprayed on for the stripes. The Silver is a Mercedes code 744 silver.
|
|
CASEYT
Sat April 12, 2003 7:53pm
|
TRUNK
TRUNK W/FUEL CELL INSTALLED ALONG WITH FUEL PUMP AND FILTER UNDER THE TRUNK FLOOR. WITH NO NOTICE AT ALL
|
|
hog
Fri September 26, 2003 6:59am
Rating: 1
|
Engine Compartment
Notice home built bracket for alternator brace.
|
|
Tongue Pirate
Sun November 30, 2003 8:14am
|
RR TL Housing
This area was a lot of work. The mold lines don't match up exactly & the compound curves make it a dificult job. Notice the pinholes. This is where sanding went through the gelcoat to the fiberglass. All in all I was really pleased with the job done here.
|
|
jwoodard
Wed March 17, 2004 7:45am
Rating: 10
|
Notice the polished rookie stripes
|
|
Brent Mills
Sun May 30, 2004 10:03am
Rating: 10
|
Progress being made on polishing....
Looks easy...It's NOT!!!! To get to this point it took me approximately 40 hours. To get all the deep marks out, it requires a lot of sanding, and of course once you start polishing, you'll end up sanding again, because you'll notice all the stuff you missed. Frustrating to say the least.
|
|
BevanWright
Tue July 27, 2004 3:53pm
|
Brake_Duct_Template
This template can be used to make a brake duct for the front brakes. It fits in behind the oval openings on the front of the car.
You will notice that a bit isnt shown (unfortunately the scanner only does A4 standard page size. You can finish by folding the image in half and tracing the other side.
You may also wish to add tags to mount to the body.
|
|
CobraDan
Tue November 9, 2004 6:41am
|
|
Michael C Henry
Mon December 13, 2004 9:19pm
Rating: 10
|
new_carb_part
notice in the square primaries, lower ventury, the little brass tube sticking out at about 7 o'clock.What is it for?
|
|
