MrMagoo
Fri August 22, 2008 5:31am
|
Broken Trailing Arm Mount
|
|
MrMagoo
Fri August 22, 2008 5:31am
|
Broken Trailing Arm Mount
|
|
MrMagoo
Fri August 22, 2008 5:31am
|
Broken Trailing Arm Mount
|
|
greg schroeder
Sun October 12, 2008 1:04pm
|
Half shaft Superformance broken
This Superformance half shaft from Ford 8.8 rear end car 2040 was broken from standing start on drag radials. The rear end was replaced with Detroit Tru-trac and the half shafts were replaced with stronger from The Driveshaft shop.
|
|
gjkrv8
Tue October 14, 2008 8:50pm
|
Broken_Temp_sensor_thread_adapter
This little bugger gave me heart failure. it borke off in the block. Had to use an "easyoout" to get it out. Though I might have had to take the whole engine out.
|
|
RJCCOBRA
Tue November 25, 2008 2:59pm
|
Shell Valley build
Rear roll bar down legs were notched and fitted. The first one was the hardest. After the correct angle and length were determined, the second one was a breeze. Good thing, since we broke Buddy's 2 inch hole saw while finishing the notch on the second down leg.
|
|
eschaider
Wed November 26, 2008 11:14pm
|
TKO Design Flaw
Third gear failure resulting from reduced torque transmission capacity in third gear as a result of reduced tooth face width contact in a TKO 600
|
|
nanard289
Thu February 5, 2009 1:04pm
|
Pin drive broken
It is the time to reinforce the original pin drive. I don't know how is the wheel transmission design to accept a big block torque? I have only a small block
|
|
rdc767
Fri March 27, 2009 4:42pm
Rating: 10
|
|
DAVID GAGNARD
Sun April 26, 2009 5:03pm
|
|
DAVID GAGNARD
Sun April 26, 2009 5:03pm
|
run-in_stand_067
broken rod bolt
|
|
DAVID GAGNARD
Sun April 26, 2009 5:03pm
|
run-in_stand_068
broken rod bolt
|
|
onefastmustang
Sun October 4, 2009 5:41pm
|
|
Bell
Wed January 6, 2010 3:08pm
|
|
D-CEL
Thu September 9, 2010 8:51am
|
broken/failed SPF shock bolt
|
|
