Danr55
Sun March 1, 2009 5:05pm
Rating: 10
|
Hooters Car Show
Second Place. A lot!
|
|
HI Cobra
Mon April 13, 2009 9:19pm
Rating: 10
|
This is why I like to go to my second home in Texas!
|
|
Dwight
Fri May 1, 2009 6:06pm
Rating: 10
|
Cobra security system
protection for my Cobra
|
|
lovehamr
Wed September 9, 2009 2:40pm
Rating: 10
|
securedownload
Wooo Hooooo
|
|
cobbindale
Sun September 13, 2009 3:28am
Rating: 10
|
Paint protection
Clear protective paint film applied to complete from section of car
|
|
Dwight
Wed October 14, 2009 8:09am
Rating: 10
|
Ed Combs DVSF IV
Ed 90 seconds after 40 plus Cobras blast by
|
|
pgermond
Sun November 1, 2009 4:34pm
Rating: 10
|
Mather Auto-X
The Mustang turned in the fastest time of the day, with the Cobra being second.
|
|
kitcarbp
Sat November 7, 2009 3:04pm
Rating: 10
|
side pipe bracket 35-183
WCC side pipe bracket with rubber insulator uses 5/16 bolts to secure
|
|
Tom Kirkham
Tue December 1, 2009 11:53am
|
Holley carb tuning
Adjusting up the secondary butterflies
|
|
Tom Kirkham
Tue December 1, 2009 11:53am
|
DSC03595_Large_
adjusting up the secondaries
|
|
phantom03
Tue February 9, 2010 11:06am
Rating: 10
|
new prototype carrier testing
not yet released to public
|
|
hogster
Sat June 5, 2010 3:02am
|
Stainless welding
Used the Henrob Oxy/Acetylene torch to have a go at 316 stainless. Not a bad effort for second try.
|
|
Jac Mac
Tue April 12, 2011 10:35pm
Rating: 10
|
9 inch Ford Independent rear center section.
9 inch Ford Diff assy, mounts on 4 pads on rear of housing plus 'ring' bracket that attach's to pinion retainer. This particular unit has now completed seven hard seasons of classic racing in a TVR Tuscan. We are now upgrading the axle shafts to 35 spline to make it totally bulletproof...if such a state ever exists!:)
|
|
terlingua71
Fri October 28, 2011 11:33am
Rating: 10
|
Terlingua Cobra the second of the six produced
|
|
nanard289
Fri December 30, 2011 1:35pm
Rating: 10
|
Building operation - second step
here I cut a 90° aluminum pipe elbow to have two small 40° elbow. This will allow to have a vertical 5° angle
|
|
