fkemmerer
Wed July 16, 2008 11:32am
|
Front Nose
Pictures of ERA #753 in the final stages of assembly. Shows the nose of the car. Note the polished aluminum pieces inside the nose including the polished fans.
|
|
fkemmerer
Wed July 16, 2008 11:32am
Rating: 10
|
Trunk and Electricals
Pictures of ERA #753 in the final stages of assembly. This shows all of the electrical pieces inside the polished trunk.
|
|
fkemmerer
Thu July 31, 2008 6:02am
Rating: 10
|
ERA 753 - IAC Details
This picture shows the inside of the intake ports on my TWM stack injection setup. The brass fitting connect to the IAC motor plumbing under the intake manifold.
|
|
priobe
Wed February 25, 2009 7:12pm
|
|
Clois Harlan
Mon March 9, 2009 6:32pm
|
Inside the bonnet
The underside of the bonnet
|
|
Clois Harlan
Mon March 9, 2009 6:32pm
|
Inside the door skin
I took this shot to show how the hinges and latches have been reinforced with steel. This is a shot seldom seen on most kit cars. By the way the latch will be electric and operable by remote, push button, or manually. Just a small liberty taken here.
|
|
Clois Harlan
Mon March 9, 2009 6:32pm
|
Coupe from the side
Bryan Anderson of B&B has done such a wonderful job on the finish of the body...Just wait until we get some paint and some very high end gauges...on the inside.
|
|
Clois Harlan
Mon March 9, 2009 6:33pm
|
Dash
Looking from the trun this is the dash and the quick release steering wheel. Just wait until we get the inside finished out with the best gauges on the market ...definetly high end!
|
|
428street
Wed March 11, 2009 10:51am
Rating: 10
|
|
Rob. Smith
Fri March 27, 2009 4:22am
Rating: 10
|
|
DocDirk
Wed April 8, 2009 8:38pm
|
Right rear lower link arm at axle
Rotated view of rear lower link arm right side showing square link arm attached inside a square receptacle on the axle...very little or no room for rotaion with axle movement.
|
|
Pete Munroe
Wed July 22, 2009 9:58pm
Rating: 10
|
ERA 289 FIA shoulder harness mount
Roll bar mount for raising the shoulder harness. Moved one of the belt anchors to the outside of the roll bar. For the inside anchor I welded a bracket on the bar. Point was to be symmetrical to where I mounted the seat. Did not mount the seat as suggested in the "offset" position. Wanted it directly back from the pedals. Did lose some leg room by not doing the normal "offset".
|
|
RedSnake351
Fri July 24, 2009 9:52pm
|
Command Post
Our usual spot, Inside Turn 5.
|
|
KarlCSX2498
Tue August 4, 2009 9:02am
Rating: 6
|
Fuel filler port, installed by Nick at Acton Custom
A very nice install by nick, fully TIG welded on the inside. A perfect job.
|
|
kitcarbp
Mon September 21, 2009 7:20am
Rating: 10
|
West Coast Griffin Rad Brackets
Here is a shot of my custom rad brackets made from 1/8 x 1.5" aluminum strip. Its a two peice design without welds and is adjustable to the core thickness. This core is 2.75" wide. I used High density EPDM sponge foam to line the inside of the bracket to absord vibration and protect the core frame.
|
|
