RJCCOBRA
Sun November 23, 2008 5:20pm
|
Shell Valley build
Hole cut for gas filler and fuel sender unit.
|
|
RJCCOBRA
Wed January 21, 2009 3:46pm
Rating: 1
|
Shell Valley build
The hood was bowed and warped so badly that we had to cut slots in the inner panel, fill with foam, and then add weight to level out the passenger's side. After the foam hardened, we put a layer of glass over the cuts and added weight again.
|
|
DocDirk
Sun March 29, 2009 7:07pm
|
Exhaust and Baffle
The Exhaulst sidepipe ID is 3 3/8", the baffle front flange fills it and has a length filling the entire sidepipe but it has an ID of just 1 7/8"
|
|
fastraxsg
Thu April 2, 2009 8:07pm
Rating: 6
|
Tank
Modified filler for Hurricane stock tank
|
|
kitcarbp
Mon April 13, 2009 6:36am
Rating: 10
|
Modified Lower Radiator Hose
Here is the modified lower hose to keep the surge tank on the LOW pressure side (water pump inlet) of the system. Not the most elegant but very functional. I found a glass filled nylon "T" taht is 1.75" and has a 1.0" fill line for the surge tank.
|
|
cobbindale
Wed April 29, 2009 10:02pm
Rating: 10
|
Bogged
Filler done. Almost ready for hi fill
|
|
cobbindale
Wed April 29, 2009 10:02pm
Rating: 10
|
Filler in doors
Body filler in doors, cowling and sills
|
|
cobbindale
Wed April 29, 2009 10:02pm
Rating: 10
|
Hi filled and sanded
Hi filled and sanded with 320 grit dry. Ready to prime.
|
|
Hawkeye
Fri June 12, 2009 11:10am
|
Paint Shop(Mould Seam grinding and filling)
|
|
Baz
Tue June 16, 2009 2:57am
|
Cobra_returns_to_Neils_Workshop_Small_
The body has been blocked, high filled then undercoated. 3 coats of duco were then applied followed by 2 coats of clear lacquer. The stripes were then applied and it was cut back before 3 flow coats applied. In 6 months time, the car has to be rubbed back and polished again.
|
|
hogster
Sat June 27, 2009 11:06pm
|
Added Filler Rod
Same procedure with the filler rod
|
|
KarlCSX2498
Tue August 4, 2009 9:02am
Rating: 6
|
Fuel filler port, installed by Nick at Acton Custom
A very nice install by nick, fully TIG welded on the inside. A perfect job.
|
|
martrogers
Fri October 2, 2009 11:59pm
|
ackit
Pic showing the drilling template with 2 holes drilled. In the background is a template I made by putting cling film on the bonnet, and getting the curve into body filler. This mould template was then used to ensure the AC would fit the curve of the bonnet.
|
|
Wbulk
Mon December 7, 2009 5:10pm
Rating: 10
|
Gas Filler Modification
Modification to a B and B fuel filler. It is just setting in place. The LeMans cap still has to be drilled.
|
|
Wbulk
Mon December 7, 2009 5:14pm
Rating: 10
|
Fuel Filler Modification
Pieces for the Modified B and B Fuel Filler.
|
|
