John Poling
Fri April 5, 2002 6:57am
Rating: 10
|
Front end
This is a shot of the front end under construction showing the dual fan assembly.
|
|
cobrajeff
Sat January 4, 2003 2:34pm
Rating: 10
|
PSE FIA wheels on ERA
On the outside, the 10.0" wheels line up about even with the wheel openings.
|
|
speed220mph
Sun January 12, 2003 11:24am
Rating: 10
|
Ride Height
Trigos: When ride height is correct, tire-to-wheel opening looks right. No one does a better job of this than ERA. Note exhaust color. When the A/F mixture is right on with leaded gas, it leaves a nice tan appearance.
|
|
speed220mph
Mon May 19, 2003 4:50am
Rating: 10
|
Invisible rock protection by Invinca Shield
3M Clear Sheet on rear fender protects paint. Edge of Clear Sheet starts at upper corner of door, extends down to bottom of fenders following door cut line and goes back up at wheel opening and back across fender to corner of door. Check it out at http://www.invinca-shield.com/.
|
|
cobrajeff
Fri June 13, 2003 4:36am
Rating: 10
|
New Ford GT's
Here are Bill Ford, John Coletti, and Steve Saleen getting ready to drive the first three "production" FORD GT's in for the opening celebration at the Ford Centennial in Dearborn, MI
|
|
cobrajeff
Fri November 7, 2003 2:31pm
Rating: 10
|
Fender Vents
I ground the inside of my fenders thinner to make the openings look like they are in an aluminum fender rather than fiberglass.
|
|
wyocobra
Sat December 6, 2003 9:45am
Rating: 10
|
wide open for air
fresh built serpant gasping for a breath of cool air
|
|
sharpe 1
Thu December 11, 2003 2:28pm
Rating: 10
|
The Main Man
This photo was taken in Dallas at the Sandersons opening back in Oct. 03
|
|
Bruce Edwards
Mon January 26, 2004 3:48pm
|
Hood seal
A picture of the hood seal and scoop opening modification.
|
|
Rodney
Wed February 25, 2004 11:23pm
Rating: 10
|
Stainless rock/bug mesh
All openings rad, oil cooler and fresh air inlets have my 304 #10 stainless steel screen which protects the rad and oil cooler and makes my car unique!
|
|
BevanWright
Tue July 27, 2004 3:53pm
|
Brake_Duct_Template
This template can be used to make a brake duct for the front brakes. It fits in behind the oval openings on the front of the car.
You will notice that a bit isnt shown (unfortunately the scanner only does A4 standard page size. You can finish by folding the image in half and tracing the other side.
You may also wish to add tags to mount to the body.
|
|
Anthony
Sat August 7, 2004 11:28am
Rating: 10
|
factory 427 High Riser intake
factory 427 HR single 4 bbl intake , I believe to be used on 427 comp cobra's. The intake originally was cast with a "4 hole" style carb pad, but someone modified it like a modern intake, with two large openings.
|
|
