RJCCOBRA
Sat December 6, 2008 2:42pm
|
Shell Valley build
Brake lines are run, and front and rear suspension reattached to the frame.
|
|
52chevyred
Tue December 9, 2008 4:18pm
|
Powder Coated Calipers and Clutch Arm
I powdercoated my front calipers Argent Silver, to match the rear calipers. I did the clutch arm, because I could. 
|
|
Ako
Sat December 13, 2008 12:43am
|
New wheels and tyres
Rears 335 30R 18
|
|
sganz
Tue December 23, 2008 9:03am
|
On the trailer after paint
Rear quarter view of the car
|
|
jersey427owner
Thu January 8, 2009 12:53pm
Rating: 10
|
Wayne's Classic Roadster
Rear view
|
|
alfy65
Mon January 12, 2009 4:51pm
Rating: 10
|
|
Ken Williams
Tue January 13, 2009 5:23pm
|
IMG_7187
Brake lines, remote resovoirs, cockpit rear bulkhead.
|
|
john chesnut
Fri January 16, 2009 9:27am
Rating: 10
|
C5SPjohn
Stock C5 Corvette wheel base and track, Z06 wheels and tires, engine moved rearward by 22 inches, 38 inches tall, 77 inches wide. When sitting my head is below head fairing.
|
|
n6opv
Thu January 22, 2009 11:07pm
|
Arntz wheel well doors
Arntz Type 4 only; not on any Butlers. There's one of these doors on each side of the car, at the rear of the rear wheel wells. They open to the space between the rear bodywork and the frame rails. This one on the passenger side allows access to the battery compartment and slide-out tray. The one on the driver's side supposedly allows you to store a collapsible spare tire but I have not found one with a small enough initial diameter to fit through the door. The wheel has to be taken off first to be able to open the doors.
|
|
Baz
Fri January 23, 2009 2:35pm
|
Rear_bumper_and_lights_fitted_Small_
|
|
Fox
Sat January 24, 2009 2:09pm
Rating: 10
|
OT '87 Carrera rear speaker grille replaced
|
|
Fox
Sat January 24, 2009 2:09pm
Rating: 10
|
OT '87 Carrera rear speaker grille stock
|
|
TWOOD
Mon February 2, 2009 1:03pm
Rating: 10
|
Upper control arm alignment brackets installed
Passenger side view from above
Note: carriage bolt clear at the rear, but just barely.
|
|
RJCCOBRA
Wed February 4, 2009 3:01pm
|
Shell Valley build
We had to relocate the rear license plate light and bracket so that the license plate would clear the trunk handle.
|
|
DocDirk
Thu February 12, 2009 9:28pm
|
Unusual rear attachment
Seems this setup won't allow any suspension travel at all...??
|
|
