speed220mph
Fri February 9, 2007 12:17pm
Rating: 10
|
Crack in Tunnel Port Head
Crack between intake-valve seat and sparkplug hole was repaired by pinning, replacing plug threads with Heli-Coil and installing new valve seat.
|
|
fastraxsg
Sun April 29, 2007 8:17pm
|
tow bar
Attaches to existing hole in middle of Torana front end, has welded vertical leg at rear to catch edge of crossmember. Drilled hole in front to attach clevis to.
|
|
1985 CCX
Tue May 8, 2007 5:17pm
Rating: 10
|
CCX with new roll bar
Roll bar tail installed and hole lined up w/o issue after 450 measurements. Wow! Needs paint and final bolt down to frame.
|
|
ebiggs1
Thu June 14, 2007 5:56pm
|
|
ebiggs1
Thu June 14, 2007 5:56pm
|
|
Burgs
Tue July 10, 2007 3:11pm
|
|
Terry Stapley
Thu August 16, 2007 2:54pm
Rating: 10
|
2007UCCcruise16
2007 Cruise Utah - Scenery - The holes are almost the same
|
|
boris_thespider
Mon November 12, 2007 7:28pm
|
|
Shelboss
Mon January 28, 2008 5:34pm
|
Trunk Stay body mounting
Cobra Restorers Trunk Stay
Mounting holes drilled and tapped into support hoop
|
|
TWOOD
Fri March 14, 2008 4:29pm
|
DOOR LATCH RELEASE LINKAGE
View at top end of lionkage with the 1/4" dia. shaft passing through the bronze bushing (epoxied to fiberglass). Lever is attached to end of shaft. Hole in shaft is threaded and has nylock jam nuts on each side.
|
|
Baz
Mon March 31, 2008 1:06am
|
Inner Exhaust for side pipes.
Took me 6 hours and 3 broken screw drivers to manually extrude every single hole. One done and one to go.
|
|
patrickt
Tue June 3, 2008 6:57am
|
|
TWOOD
Mon September 1, 2008 3:51pm
|
SAME BRACKET BACK TO BACK
Assuming that the reatangular side should be placed on the frame and the "ears" ar ewhere the control arms mount.
This would place the left and right control arms in different planes and not parallel to each other.
The rectangular side has a interference with the shock tower and the mounting holes do not align and not adjustment is possible.
|
|
TWOOD
Mon September 1, 2008 3:51pm
|
Same bracket back to back with irregular side on frame
This position permits the irregular ear side of the bracket to fit around the shock tower and any of the holes can align with the slots in the frame.
|
|
TWOOD
Mon September 1, 2008 3:51pm
|
alternate possible position, rectangular side to frame
Note straight edge of bracket is in contact with the shock tower and the only one of the two holes will align with the mounting bolts.
|
|
