Rick Parker
Thu April 6, 2006 7:24pm
Rating: 10
|
Water/Fuel manifold
A lot of fabrication required to make the welded Fuel/Water Manifold. Lots of fun on the mill & lathe.
|
|
speed220mph
Wed April 12, 2006 8:24am
|
|
hotrods27
Thu April 27, 2006 9:40am
Rating: 10
|
|
Asking $26,200 It is a 289 with fuel injection, 24 lb injectors, Harland Sharp roller rocker arms, Edelbrock Performer RPM manifold, a small ISKY performance cam with 467. lift and has great mid-range power and wines up quick. Only has 2834 miles on it and ready to drive anywhere.
|
|
nanard289
Sat May 6, 2006 1:39pm
Rating: 10
|
Special intake manifold
After several weeks of work my special inlet manifold is ready. I hope to be able to test it next month (exhaust pipes are not yet welded). It is not easy to adapt properly a set of Weber 48IDF on Yates head cylinders but I am confident about the result.
|
|
Mike Simard
Wed May 24, 2006 1:54pm
Rating: 10
|
MANIFOLD9
Center area, vacuum manifold where the map sensor gets its signal
|
|
nanard289
Mon July 24, 2006 4:34am
Rating: 9.8
|
Weber_manifold_modification
Big job to adapt a weber manifold on Yates head cylinders. I start from a 351 Cleveland manifold (from de Tomaso Panthera) and a J Roush manifold for Holley carb to finish on a 302 Windsor with the top of the first and the bottom of the second
|
|
54popular
Sat November 4, 2006 6:48pm
Rating: 10
|
|
54popular
Sat November 4, 2006 6:48pm
Rating: 10
|
|
cobrajeff
Fri November 10, 2006 12:46pm
Rating: 10
|
Weber intakes for 351C
The lower manifold is a standard Weber intake for a 351 Cleveland. The upper one is port a 351C with "High-Port" heads. Note the difference in material above and below the port on the two manifolds.
|
|
Jerry Clayton
Mon February 5, 2007 12:34pm
Rating: 10
|
LS 1 goodies
Edelbrock manifold
|
|
Jerry Clayton
Mon February 5, 2007 12:34pm
Rating: 10
|
LS 1 goodies
Edelbrock manifold
|
|
Jerry Clayton
Mon February 5, 2007 12:34pm
Rating: 10
|
LS 1 goodies
Edelbrock manifold and Dart heads
|
|
greg schroeder
Mon February 19, 2007 5:30pm
|
dynojet 475.3 wheel HP
Roush 427R-095 single plane intake manifold
Pro-Systems 1000 cfm carb
oval 2.25 in. high air cleaner
2" primary headers
Buckshot Racefab side pipes
|
|
496fe
Wed April 18, 2007 8:20pm
Rating: 10
|
New manifold
Had to lower the air cleaner to fit under the hood
|
|
Rick Parker
Sun July 8, 2007 1:32pm
Rating: 10
|
48IDA's
NOS Manifold, 48 IDA Italian Carbs, Holley Regulator, almost ready wating for the jets.....
|
|
