DocDirk
Wed April 8, 2009 7:27pm
|
Rear of lower link arm
This looks like it will bind if the axle moves up at all, will probably have to be rounded off. The arm has two welded bends in it so I doubt I can replace it accurately with a tube.
|
|
Austin_Snake
Thu April 9, 2009 7:36am
Rating: 10
|
Exact 427 Belt attachment
Welded roll bar seat belt attachment
|
|
fastraxsg
Wed May 20, 2009 8:45am
|
welding blind
I took this photo in Singapore in the early 80's. I doubt Ho Siang is doing this anymore. His answer to any question was "no problem."
|
|
hogster
Sat June 27, 2009 11:05pm
|
1.75 Inch Mild Steel tubing
cleaned up and read for fusion welding
|
|
hogster
Sat June 27, 2009 11:06pm
|
Tack welding
A couple of tack welds to hold everything together
|
|
hogster
Sat June 27, 2009 11:06pm
|
Fusion Weld finished
Just drag the weld pool around the join
|
|
Pete Munroe
Wed July 22, 2009 9:58pm
Rating: 10
|
ERA 289 FIA shoulder harness mount
Roll bar mount for raising the shoulder harness. Moved one of the belt anchors to the outside of the roll bar. For the inside anchor I welded a bracket on the bar. Point was to be symmetrical to where I mounted the seat. Did not mount the seat as suggested in the "offset" position. Wanted it directly back from the pedals. Did lose some leg room by not doing the normal "offset".
|
|
KarlCSX2498
Tue August 4, 2009 9:02am
Rating: 6
|
Fuel filler port, installed by Nick at Acton Custom
A very nice install by nick, fully TIG welded on the inside. A perfect job.
|
|
Baz
Thu September 17, 2009 2:41am
|
Heat_Shields_for_Side_Pipes_Small_
Stainless Steel Side Pipes fitted. They have to have the welding ground smooth and polished.
|
|
kitcarbp
Mon September 21, 2009 7:20am
Rating: 10
|
West Coast Griffin Rad Brackets
Here is a shot of my custom rad brackets made from 1/8 x 1.5" aluminum strip. Its a two peice design without welds and is adjustable to the core thickness. This core is 2.75" wide. I used High density EPDM sponge foam to line the inside of the bracket to absord vibration and protect the core frame.
|
|
lovehamr
Sun October 25, 2009 7:38pm
|
new_headers_2
BDR headers for FE; check out the collector flange welding, or lack there of. Think these would leak?
|
|
Dwight
Thu November 26, 2009 7:47pm
|
back room of the shop
welding area in the shop
|
|
Wbulk
Fri December 4, 2009 8:59am
Rating: 10
|
Clutch Quadrant Modification on B and B
Cut off existing bracket and welded on the extra steel on the left to bolt a modified Ford Racing clutch quadrant to the arm. Much better and smoother operation.
|
|
cobrajeff
Tue December 22, 2009 8:17am
|
Cage
Cage welded into cowl sides, and tunnel brace extended down to meet the frame rails.
|
|
cobrajeff
Tue December 22, 2009 8:18am
|
Cage
Stu Galbraith of Weldcraft came out of retirement to do my cage.
|
|
