cobrajeff
Tue December 2, 2003 5:24am
Rating: 10
|
Collapsible Spare Tire
Here is my "standard" load - Collapsible Spare seated between Halon and Battery box (air inlator bottle in green "wine cooler" bag).
Two folding chairs, California Duster, and emergency tool kit on lower level. Small scissors jack, knock-off hammer, safety wire & pliers, couple screwdrivers and spark plug socket w/rachet.
Soft top is only loaded when it looks like it will be needed. Miscellaneous "waxer" supplies in small black box to right of tool box.
|
|
NMattison
Mon February 2, 2004 5:42am
|
|
Tony Radford
Mon February 9, 2004 6:43am
Rating: 10
|
Serpent Express
Easy loading with beavertail and wide, slide-out ramps.
|
|
W. MITTY
Mon February 9, 2004 10:25pm
Rating: 10
|
Thomas Kirkham, Man of Iron
Thomas single handedly loads the 427 into the waiting trailer while I shout words of encouragement from behind the camera
|
|
W. MITTY
Mon February 9, 2004 10:43pm
|
Destination: Kirkham Motorsports, Provo, Utah
And so the journey from Northern Arizona to Provo, Utah, begins. The Cummins Turbo Diesel is locked and loaded, pizza and books on tape at the ready.
|
|
Side Oil'r 69
Wed February 11, 2004 4:36am
Rating: 10
|
KMP_Kee_shaft
David Kee Top loader & Chromoly drive shaft
|
|
bdriver
Sat March 13, 2004 5:05pm
|
Loadout at the Kirkham to a new home
|
|
MysteryTrain
Sun August 15, 2004 3:30pm
Rating: 10
|
Enzo at Monterey, 2004
Owner drove from Utah to Monterey to give a kid a ride on the track for Make a wish foundation. Front intakes were loaded with sand & road grit!
|
|
DAVID GAGNARD
Wed October 6, 2004 9:37am
|
wheel chocks
wheel chocks and paint marks on trailer to line up my car for loading....
|
|
froggyman
Mon January 17, 2005 12:36pm
Rating: 8.66667
|
SPF1649 going to Omaha
The car being loaded into Rich Lacy's Trailer enroute to Omaha, NE.
|
|
froggyman
Mon January 17, 2005 12:38pm
Rating: 10
|
SPF1649 Waiting to be loaded up
|
|
Mulv
Sat February 5, 2005 5:33pm
Rating: 10
|
Loaded up and ready
3.0 Ranger with Superformance car - all within capacity!
|
|
CobraKid427
Wed February 23, 2005 9:06pm
Rating: 10
|
|
simon clemens
Fri March 18, 2005 4:14am
|
New Crank Pully
I had a crank pully custom made out of aluminium, the original pully had too many un-needed bits. I also wanted the power steering pump rpm reduced, so I had a smaller pully machined, this should also reduce some load on the engine 
|
|
kitcarbp
Sun May 15, 2005 5:23pm
Rating: 10
|
460 Crate Off- Loading
.... and the dealership all gathered round as we loaded this into the pick-up behind Koons Ford in Sterling, sure hope it works after all this trouble !
|
|
