John Poling
Mon August 4, 2003 4:44am
Rating: 7
|
Rear Axle With Brace
Added this brace to the rear of my axle housing to help keep it from flexing.
|
|
John Poling
Mon August 4, 2003 4:45am
Rating: 5.5
|
Rear Axle With Brace
Added this brace to the rear of my axle housing to help keep it from flexing.
|
|
John Poling
Mon August 4, 2003 4:46am
Rating: 5.5
|
Rear Axle With Brace
Added this brace to the rear of my axle housing to help keep it from flexing.
|
|
John Poling
Mon August 4, 2003 4:47am
Rating: 5.5
|
Rear Axle With Brace
Added this brace to the rear of my axle housing to help keep it from flexing.
|
|
speed220mph
Tue October 7, 2003 3:37pm
Rating: 10
|
K&N filters replace Snelling & Hellings
Will supply airflow numbers at a later date for both filters. Filters shown are K&N's part # E-2570's using Snelling & Hellings housings.
|
|
Tongue Pirate
Sun November 30, 2003 8:14am
|
RR TL Housing
This area was a lot of work. The mold lines don't match up exactly & the compound curves make it a dificult job. Notice the pinholes. This is where sanding went through the gelcoat to the fiberglass. All in all I was really pleased with the job done here.
|
|
Aussie Mike
Tue June 1, 2004 11:50pm
|
New diff fill plug
I machined the dif rear cover to fit a fill plug then I bored and slieved the rear cross member to give me access to it. the original Ford diff had the fill plug in the housing but this new diff doesn't have one.
|
|
kitcarbp
Tue August 31, 2004 6:30pm
Rating: 10
|
460 Manual Cast Iron Ford Bell Housing (aka 351M/400M Bronco)
351M/400M bell housing- This was actually the first part purchased for my project, wow, what a long strange trip its been ! This required the use of a short-input shaft TKO 600 kit. I used a needle bearing type crankshaft pilot bearing.
Re-cond bell housing waiting for her mate for life
uses a top-loader bolt pattern and only 6.25 inches deep great for STREET duty Cobras. Total investment was $210 after heli-coil repair
|
|
Rick Parker
Tue October 12, 2004 8:54pm
Rating: 10
|
|
