BlueRooster
Wed November 3, 2004 4:48pm
|
|
mloy
Mon February 7, 2005 9:11am
Rating: 10
|
Front Uprights
Front Uprights for 289 Leaf Spring. Manufactured by Accurate Machine Products.
|
|
mloy
Mon February 7, 2005 9:14am
Rating: 10
|
Front Uprights - Back side
The casting and machine quality is very high on these parts.
|
|
simon clemens
Fri March 18, 2005 4:14am
|
New Crank Pully
I had a crank pully custom made out of aluminium, the original pully had too many un-needed bits. I also wanted the power steering pump rpm reduced, so I had a smaller pully machined, this should also reduce some load on the engine 
|
|
Unregistered
Sat March 19, 2005 12:19am
|
Steering wheel hub
First steep, we have to cut a large aluminum slice and to machine it on the lath
|
|
cobrajeff
Wed March 23, 2005 9:26am
Rating: 10
|
Plastic Valve Covers
Here are two sets of plastic COBRA valve covers I made in the 70's. Thought the clear ones would really be cool. To really get the detail, I would have had to drill small air holes in them to get the vacuum machine to work well - I wasn't willing to do that.
|
|
phatry5
Sun April 17, 2005 10:08pm
|
my garage
left to rigth, 1967 stang, 65 cobra, 04 Mach 1
|
|
phatry5
Sun April 17, 2005 10:13pm
|
Dash
All digital, with custom machined rings around each
|
|
jeffw
Sat April 30, 2005 8:32pm
|
Headed to Columbus
On display at the Precision Machine Tool Show - Columbus Convention Center May 2 - 5.
|
|
mickmate
Mon May 23, 2005 6:57am
|
Machining pedals
This set up worked well to machine the slots on the back of the pedal pads.
|
|
lovehamr
Thu June 9, 2005 8:38pm
|
Champions
The man and his machine
|
|
Tongue Pirate
Sat July 2, 2005 9:14pm
|
13" Short
Fresh Driveline Install
|
|
jdean
Sat August 6, 2005 7:07pm
Rating: 10
|
|
nanard289
Thu September 1, 2005 12:54pm
Rating: 7
|
shifter step 7
I have to machine a small button to move the reverse locker
|
|
Gerry K
Sun November 6, 2005 5:37am
|
|
