jdean
Mon July 20, 2009 7:15am
Rating: 10
|
Unloading at Larry Goins shop
Larry is just moving into his new shop in Jay OK
|
|
RedSnake351
Fri July 24, 2009 9:52pm
|
|
kitcarbp
Tue September 29, 2009 7:22am
Rating: 10
|
First Start-Up Roll-Out
Here is a shot just before I started her in the drive.
It has taken me about 5 years to get to this point and boy is this fun!
|
|
martrogers
Fri October 2, 2009 11:59pm
|
ac4
Logo in position, just need to remove tape and fix from the underside (which means taking out radiator, draining down etc)
|
|
Hotfingrs
Mon October 5, 2009 6:55am
|
|
Z-linkCobra
Mon October 19, 2009 1:58pm
|
Build pics
Just another view.
|
|
Z-linkCobra
Mon October 19, 2009 1:58pm
|
Build pics
Just another view.
|
|
*13*
Wed November 25, 2009 8:43pm
Rating: 10
|
289 Weber Fuel Routing
Just re-did the Fuel routing. Fun Project.
|
|
*13*
Sun November 29, 2009 3:49pm
Rating: 10
|
Weber Filters (Home Made)
Just a first try. SS mesh & Neoprene caps from McMaster Carr. Just wanted to see if it would work. Now that I know they do, I can clean them up a bit. Blurry picture is hiding the dirty engine compartment.
|
|
Wbulk
Mon December 7, 2009 5:10pm
Rating: 10
|
Gas Filler Modification
Modification to a B and B fuel filler. It is just setting in place. The LeMans cap still has to be drilled.
|
|
Z-linkCobra
Thu December 31, 2009 5:43am
|
Valley area of the block
Just a pic to show the valley area and reinforcements that are casted into this block.
|
|
52chevyred
Fri January 1, 2010 6:51am
|
351W with SB Headers
This is the dummy 351W with the headers from Street Beasts. Earlier, I tried Factory Five headers, but they just wouldn't work out on this body.
|
|
Z-linkCobra
Fri January 22, 2010 7:29am
|
SNAKE!!!!!!
Just a baby rattler the dogs were jackin with outside the shop. I like snakes just fine...but not the ones with rattles.
|
|
kitcarbp
Fri January 22, 2010 12:19pm
Rating: 10
|
V8 oil cooler
Ford Explorer V8 oil cooler. LONG made this OEM oil cooler for the mid 90's Explorers, if I can shoe horn this into place, it just might be the cooler I was looking for to keep the 460 oil temps uniform. This is hooked up in-line with the lower rad hose. This should have very good water flow rates to cool the oil.
|
|
Bobcat
Tue February 2, 2010 11:13am
|
|
