big-boss
Fri February 15, 2008 7:34am
Rating: 10
|
Feb 2008
Oil System plumbed. I used the bad boy push on hose and light weight fittings. Was the easiest and I liked the looks.
|
|
krazykarl
Tue February 19, 2008 6:37pm
|
Mcleod flywheel and pressure plate
Mcleod flywheel and pressure plate only weighs 21 lbs total
|
|
khansmith
Wed February 20, 2008 1:22pm
Rating: 10
|
Rear of the car after body install rear tail lights, etc
These document different stages of my build.
|
|
TWOOD
Sun February 24, 2008 10:04am
Rating: 10
|
Harness from dash to front and rear
The harness passes through the firewall, above the transmission, and splits into three directions. 1. left side of engine (temp sensors, distributor, horn, lights). 2. right side of engine (battery, starter, alternator). 3. Everything at rear of car.
|
|
TWOOD
Fri March 14, 2008 4:34pm
Rating: 10
|
door latch release linkage
View of lower end of linkage. Very much the same as drawing that Art Burtt has posted. Spring is secured to wheel well liner with a machine screw, short lenght of safety chain, a key ring. Light colored material behind the safety chain is insulating foam.
|
|
cobrajam
Tue April 8, 2008 7:22pm
|
InsideOfSteeringHub_Medium_
Ok, I got a chance to pull hub off of column. Still do not see any numbers, but general design suggests 60s-70s. Looking a pic above for reference, the wire color as follows:
L to R Top Row - Blank spot / White with blue stripe / Solid blue / Yellow with black stripe
L to R Bottom Row - Blank spot / Solid red / Green with white stripe / Solid light green
|
|
Dans65
Tue April 8, 2008 7:38pm
|
Dans65 FFR
All the lights are installed and functioning perfectly, we are amazed no cliches from our wire trimming the original wire harness from my donor car.
|
|
Baz
Thu April 17, 2008 8:45pm
|
Get out the hacksaw and drill.
The floor of the boot was removed today in readiness for the installation of the fuel tank. Rear lights were positioned and drilled as was the rear number plate light on the boot lid.
|
|
patrickt
Sun April 27, 2008 12:38pm
|
|
Dwight
Fri May 2, 2008 4:17pm
|
Shell Valley Coupe
Mike's Coupe tail lights installed
|
|
vanoochka
Mon July 28, 2008 8:29pm
|
Coast Cruise - July, 2008
|
|
vanoochka
Mon July 28, 2008 8:29pm
Rating: 6
|
Coast Cruise - July, 2008
|
|
patrickt
Sun November 2, 2008 11:33am
|
Ignition Switch w/ Trouble Light
|
|
scales
Wed November 19, 2008 1:46am
Rating: 10
|
Night Rally Kit installed. Nov.18,2008
The Night Rally Kit was only availible in 1966. Availible from all Ford dealers. The kit relocated the Mustang Fog Lights to the lower Valance.
|
|
Merv and Sharon
Tue December 16, 2008 10:18pm
Rating: 10
|
|
