rdc767
Tue July 14, 2009 2:45pm
|
license bracket
license bracket
|
|
Pete Munroe
Wed July 22, 2009 9:58pm
Rating: 10
|
ERA 289 FIA shoulder harness mount
Roll bar mount for raising the shoulder harness. Moved one of the belt anchors to the outside of the roll bar. For the inside anchor I welded a bracket on the bar. Point was to be symmetrical to where I mounted the seat. Did not mount the seat as suggested in the "offset" position. Wanted it directly back from the pedals. Did lose some leg room by not doing the normal "offset".
|
|
Wbulk
Thu July 30, 2009 12:56pm
Rating: 10
|
Kirkham Alternator Bracket on a B and B
Reasonably priced bracket that allows the alternator to be mounted between the frame and out of the way of the upper hose. I think I paid $50 from Kirkham Motorsports.
|
|
kitcarbp
Mon September 21, 2009 7:20am
Rating: 10
|
West Coast Griffin Rad Brackets
Here is a shot of my custom rad brackets made from 1/8 x 1.5" aluminum strip. Its a two peice design without welds and is adjustable to the core thickness. This core is 2.75" wide. I used High density EPDM sponge foam to line the inside of the bracket to absord vibration and protect the core frame.
|
|
fkemmerer
Sun October 4, 2009 2:30pm
|
Oil Thermo 3
Custom Bracket to mount a Canton Oil Termostat in an ERA 427SC
|
|
fkemmerer
Sun October 4, 2009 2:30pm
|
Oil Thermo 1
Custom Bracket to mount a Canton Oil Termostat in an ERA 427SC
|
|
fkemmerer
Sun October 4, 2009 2:30pm
|
Oil Thermo 4
Custom Bracket to mount a Canton Oil Termostat in an ERA 427SC
|
|
fkemmerer
Sun October 4, 2009 2:30pm
Rating: 10
|
Oil Thermo 2
Custom Bracket to mount a Canton Oil Termostat in an ERA 427SC
|
|
fkemmerer
Thu October 8, 2009 10:31pm
|
Oil Thermostat - Final assembly before installation in the car.
This shows the Canton Oil Thermostat installed in a custom made bracket prior to installation in the car.
|
|
kitcarbp
Sat November 7, 2009 3:04pm
Rating: 10
|
side pipe bracket 35-183
WCC side pipe bracket with rubber insulator uses 5/16 bolts to secure
|
|
priobe
Wed November 11, 2009 7:19am
|
|
priobe
Wed November 11, 2009 7:19am
|
|
priobe
Wed November 11, 2009 7:19am
|
|
kitcarbp
Fri December 4, 2009 6:32am
Rating: 10
|
lokar edelbrock bracket installed on my 460 Ford
|
|
Wbulk
Fri December 4, 2009 8:59am
Rating: 10
|
Clutch Quadrant Modification on B and B
Cut off existing bracket and welded on the extra steel on the left to bolt a modified Ford Racing clutch quadrant to the arm. Much better and smoother operation.
|
|
