traindriver
Mon September 20, 2004 6:29pm
Rating: 10
|
Good Bye 4bbl, hello Webers!
|
|
cobrajeff
Thu September 30, 2004 5:01am
Rating: 10
|
|
cobrajeff
Thu October 14, 2004 5:41am
Rating: 9.8
|
ERA 351 FIA
BOSS 351C small block in my ERA FIA car. Aussie block, solids, 48 IDA's - sweet music through the pipes - it doesn't get much better than this.
|
|
nikbj68
Wed November 10, 2004 2:18pm
Rating: 10
|
Kirkham FiA with Webers
Hawk stand at the NEC Classic Car Show 2004
|
|
cobrajeff
Sat November 20, 2004 1:19pm
Rating: 10
|
Cobra Club Open Track
CSX2550 (289 Cobra), COX6122 (AC289), and CSX3311 (427 "street" Cobra with stripes, pipes, and Webers) in the pits at Waterford Hills. Labor Day weekend 1975, I believe
|
|
cobrajeff
Sun November 21, 2004 6:35am
Rating: 10
|
Weber Float Adjustment
This is a tool used to bend the tang to adjust the float level on Webers.
|
|
cobrajeff
Sun November 21, 2004 12:04pm
Rating: 10
|
351C Weber Intakes
My "old" Weber manifold on left - "new" intake for B351 High Port Aluminum heads. The SVO manifoold popped up on e-bay at exactly the right time.
|
|
cobrajeff
Sun November 21, 2004 12:06pm
Rating: 10
|
Weber intakes
My new SVO intake on right, after milling "Hall Pantera" out of the valley, and adding a rear stud for new linkage.
|
|
cobrajeff
Sun November 21, 2004 12:08pm
Rating: 10
|
351C Weber intakes
High-Port manifold on right. Note vacuum holes on inboard side, as opposed to th eold intake, where they were outboard.
Two bosses on intake for "hard" linkage, as opposed to th e"cable" linkage of the Pantera system.
|
|
cobrajeff
Sun November 21, 2004 12:11pm
Rating: 10
|
Weber intake
Vacuum lines on modified 351C Weber intake. One port in front for distributor, one in back for automatic tranny.
|
|
cobrajeff
Sun November 21, 2004 12:28pm
Rating: 10
|
Weber linkage
Weber "hard" linkage for system with carbs facing opposite each other (unfinished).
|
|
cobrajeff
Sun November 21, 2004 12:30pm
Rating: 10
|
Weber linkage
Splined shaft from Enderle Injection for Weber "hard linkage".
|
|
computerworks
Sat January 1, 2005 6:50pm
Rating: 10
|
|
cobrajeff
Sun January 2, 2005 1:16pm
Rating: 10
|
Weber intake
Note the pads under carbs have been reduced 1/4" to increase hood clearance.
|
|
cobrajeff
Sun January 2, 2005 1:16pm
Rating: 10
|
Webs2
Here is what the Webers looked like on my 351C - poking thru the hood. I milled 1/4" off the top of the manifold to increase clearance.
|
|
