Brent Mills
Sat March 5, 2005 11:50pm
Rating: 10
|
kmp286
Kirkham KMP286 mostly finished up front. Still have quite a bit of final polishing, but you can't tell from a couple feet away.
|
|
marcocsx3121
Sun March 13, 2005 6:23am
|
What I rode when I was still 50-something
|
|
Bruce Edwards
Tue March 15, 2005 4:16pm
|
Bill's ERA 298 #2097 left front end 2
Another picture of the front end parts on Bill's car. Still needs to be cleaned after all of the wet sanding.
|
|
Bruce Edwards
Tue March 15, 2005 4:34pm
Rating: 10
|
Bill's ERA 298 #2097 steering rack
A Flaming River rack for the car. Still need to clean all that paint residue from the wet sanding prep off.
|
|
simon clemens
Wed April 27, 2005 7:24am
|
Brake relocation
Rear brake relocation was needed to allow clearance between the coilovers and the calipers. Re-drilled calliper mount bracket holes so the caliper sits about 40 degrees foward from original position. Also had to swap Left & Right brake assemblys to opposite sides, so the hand brake cable now will run on top of the axle & still be accuated by a foward movement. I wonder if others have thought of this solution?
|
|
TampaFla
Wed May 4, 2005 5:44am
Rating: 9
|
SideView
Still wait listed (month ??) for PS Wheels but "on the road" with AR's.
|
|
cobrajeff
Fri May 13, 2005 12:39pm
Rating: 10
|
Original FIA "Trunk Dimples"
This is the decklid of CSX2345, reported to be the only original 289 FIA car still wearing it's original skin.
|
|
Marty256
Fri June 3, 2005 8:18pm
Rating: 10
|
70 b2
still under re-construction
|
|
4RE KLR
Wed June 8, 2005 9:11am
Rating: 10
|
Gotcha!
Look close. Chris' shirt is still dry in some spots. He said "Mom is going to be livid"
|
|
4RE KLR
Wed June 8, 2005 9:31am
Rating: 10
|
Lake Yellowstone
The water is so calm some of it was still frozen over in late May 2005.
|
|
4RE KLR
Wed June 8, 2005 10:08am
Rating: 10
|
Renewed our vows
Yes I would do it all over again. After twenty years together I still love my wife!
|
|
cobrajeff
Sun September 4, 2005 7:39am
Rating: 10
|
Roll bars
I have braced my roll bar fore-and-aft, and welded-in side impact braces, too. Still looks "period-correct" from the outside, but provides a little extra protection.
|
|
Barry Nelson
Thu October 13, 2005 1:57pm
|
scan0006
I'm Talking about the car setup with Allan note the car is still in undercoat
|
|
fasterpatrick
Tue November 8, 2005 8:19pm
Rating: 10
|
still have more tooling on order
yes those are full
|
|
W2zero
Fri November 18, 2005 9:20pm
|
Passenger side view 130 amp alt
Now I'm pumpin some power. 55 amp wasnt' enough. Still have to clean up the wiring.
|
|
