cheesepocket
Wed May 8, 2002 6:54am
Rating: 10
|
Engine bay
351W crate motor from Ford, handmade headers, custom aluminum fenderwell liners, lots o' work.
|
|
venous
Sun June 2, 2002 5:58pm
Rating: 9
|
|
cobrajeff
Sat October 5, 2002 1:17pm
Rating: 10
|
Electric Fuel Pump
Holley electric fuel pump mounted in fenderwell behind left rear tire
|
|
dkjos
Sat November 2, 2002 7:26am
Rating: 10
|
Rear Fender
Rear Fender modified for "street" gas cap
|
|
speed220mph
Tue December 31, 2002 6:05pm
|
Right front corner
Distinctive features of Cobra at side of right front: vent, fender flare, side exhaust and wheels.
|
|
snakeeyes
Wed January 22, 2003 3:37pm
|
Close-up of front-end paint scheme
Black triangles over fenders were intended to reduce glare off of the white paint--
|
|
STROKER
Mon February 3, 2003 5:23pm
Rating: 10
|
All Aluminum Trunk
A total of 48 individual panels were used to Fabricate the Trunk and inner Fender well's from the backseat to the Rear of the car. Not Including the Fuel Tank. All Panel's are Brushed or polished and coverd with Zoop's Seal to preserve finish.
|
|
cobrajeff
Sat March 15, 2003 5:25am
Rating: 10
|
CSX2457
CSX2457 has undergone a few modifications - fender flares, hood scoop, oil cooler, pin-drive knock-offs. Topped out with a small-block pushing 498hp (on the dyno) with Webers.
Should be ready for SAAC28.
|
|
Rick Bagley
Tue March 18, 2003 6:36pm
Rating: 10
|
Fender
Using Eastwoods 2 part Bed Liner, spray application
|
|
Chris Moakley
Thu March 27, 2003 3:03pm
|
Still Scruffy
FFR w/ modified rear fenders. People try to tell me that primer is "in".
|
|
cobrajeff
Wed April 16, 2003 2:00pm
Rating: 10
|
RR wheel house
Here you can see I sanded the undersides of the rear fenders and added 3/16" foam to protect from stones.
|
|
cobrajeff
Wed April 16, 2003 2:04pm
Rating: 10
|
Front fender underside
Here is the LF fender from underneath. Underside is sanded smooth, added a slight rolled edge to simulate an original aluminum fender.
|
|
cobrajeff
Wed April 16, 2003 2:12pm
Rating: 10
|
Rolled fender lips
I had the bottom sides of the fenders sanded smooth, and added 3/16" foam padding to them to protect from stone chips "starring" the paint from the bottom side.
|
|
speed220mph
Mon May 19, 2003 4:50am
Rating: 10
|
Invisible rock protection by Invinca Shield
3M Clear Sheet on rear fender protects paint. Edge of Clear Sheet starts at upper corner of door, extends down to bottom of fenders following door cut line and goes back up at wheel opening and back across fender to corner of door. Check it out at http://www.invinca-shield.com/.
|
|
Boudy
Thu July 3, 2003 12:39pm
Rating: 10
|
|
