cay5628
Sat May 2, 2009 10:15am
|
Front Suspension
Front suspension assembly, after powder coating frame and control arms
|
|
DocDirk
Tue May 5, 2009 7:44pm
|
Wear on upper arm
The upper arm struck the frame mount with any attempt at vertical suspension travel in the rear.
|
|
Wbulk
Thu July 30, 2009 12:56pm
Rating: 10
|
Kirkham Alternator Bracket on a B and B
Reasonably priced bracket that allows the alternator to be mounted between the frame and out of the way of the upper hose. I think I paid $50 from Kirkham Motorsports.
|
|
kitcarbp
Mon September 21, 2009 7:20am
Rating: 10
|
West Coast Griffin Rad Brackets
Here is a shot of my custom rad brackets made from 1/8 x 1.5" aluminum strip. Its a two peice design without welds and is adjustable to the core thickness. This core is 2.75" wide. I used High density EPDM sponge foam to line the inside of the bracket to absord vibration and protect the core frame.
|
|
jdean
Sun September 27, 2009 4:24pm
Rating: 9
|
|
cobramatt
Fri November 13, 2009 9:13am
|
Full frame built under car (no more unibody) as well as two torque boxes
|
|
kitcarbp
Mon November 23, 2009 12:50pm
Rating: 10
|
ps_cooler_connections
Derale Frame Rail Oil cooler for power steering with -6AN full swivel connections. This mounts down low in front of my radiator.
|
|
kitcarbp
Sat November 28, 2009 5:27pm
Rating: 10
|
Derale PS cooler installed
The 24 inch frame rail cooler worked great on my mounts in front of radiator. This cooler reduced my reservoir fluid temps from 250F down to 140 F !
|
|
Wbulk
Fri December 4, 2009 9:32am
Rating: 10
|
The Start With A Bare Frame
Painted Frame
|
|
Rob. Smith
Mon December 7, 2009 3:17am
Rating: 10
|
Before_after_1
The new frame is more structurally sound than the original
|
|
Rob. Smith
Mon December 7, 2009 3:17am
Rating: 10
|
Chopped_1
This is the slight modifications done to the frame
|
|
Rob. Smith
Mon December 7, 2009 3:17am
Rating: 10
|
Original_seat_1
This is the ADR approved seat frame supplied by RMC
|
|
cobrajeff
Tue December 22, 2009 8:07am
|
Cut-off frame rails
To make room for 427-style side exhaust, ERA modified my outer frame rails - thye had to be cut short to make room for the pipes to go through the body.
|
|
cobrajeff
Tue December 22, 2009 8:07am
Rating: 10
|
Inside detail
Showing cut-off frame rail
|
|
cobrajeff
Tue December 22, 2009 8:17am
|
Cage
Cage welded into cowl sides, and tunnel brace extended down to meet the frame rails.
|
|
