Wbulk
Fri December 4, 2009 9:32am
Rating: 10
|
The Start With A Bare Frame
Painted Frame
|
|
cobrajeff
Tue December 22, 2009 8:17am
Rating: 10
|
Finished roll cage with front-and-rear braces on the roll bar
|
|
cobrajeff
Tue December 22, 2009 8:18am
Rating: 10
|
Cage
Cage tied into roll bar
|
|
cobrajeff
Wed December 23, 2009 6:45am
Rating: 10
|
Integral side-impact bars tied into chassis
|
|
cobrajeff
Wed December 23, 2009 7:22am
|
first outing as a running car
my ERA at Road America for the SAAC Convention in 1997 - barely running
|
|
B&B-Cobra
Sun January 17, 2010 6:37pm
|
09_013
Body back on, final wiring, windhshield mounts, roll bar
|
|
Bob Broberg SPF667 460BB
Sat February 20, 2010 6:07pm
Rating: 10
|
Colt_King_Cobra_SS_4_inch_barrel
|
|
Kimark55
Sun April 4, 2010 3:14pm
Rating: 10
|
Full Roll Bar
Full Roll Bar
|
|
Wbulk
Fri May 7, 2010 11:44am
Rating: 10
|
Ball Joint Seal Ring
This is a Fix for A Arms that use the Chrystler ball joint without a seal groove machined in. This one was from B and B. A 3/16" steel ring was added to accept the ball joint seal. It was tack tig welded on the outside edges. The rings were cut on a water jet by Kirkhams Motorsports. Barry McGill can also do the fix.
|
|
Wbulk
Sun May 9, 2010 9:03am
Rating: 10
|
Ball Joint Seal Ring
A fix for A Arms shipped without the ball joint seal groove machined in. Ring added to accept a Chrystler Ball Joint Seal. The 3/16" thick rings were cut on Kirkhams Motorsports water jet. Barry McGill can also do the fix. The bad thing was B&B sent me the wrong arms that I paid to get fixed.
|
|
dcdoug
Thu May 13, 2010 2:25pm
|
Bare NOS 427 Side oiler block
|
|
Wbulk
Sat May 15, 2010 6:40am
Rating: 10
|
Full Roll Bar Home Built
2", .120 wall tubing designed to be chromed. You have to allow for chrome thickness where the tubes slid together. A lot more work than I thought. $175 invested so far. Bending and chrome brought the cost up to about $400.
|
|
hogster
Wed May 26, 2010 6:38am
|
sidepipe2
Down the barrell
|
|
Wbulk
Mon July 12, 2010 11:05am
Rating: 10
|
Roll Bar Installed
Body cut outs took time and patience. It was scary and I'm glad that's done.
|
|
67JET
Thu September 23, 2010 8:20pm
|
Down to bare metal and Toby is utilizing my rattle can Eastwood Frame P
|
|
