RJCCOBRA
Wed January 21, 2009 3:46pm
|
Shell Valley build
The dash panel has been roughed in and the wiring done behind the panel. We need to scroll the edges and make a cover for the slot where the steering column goes through the dash. Then it's on to covering the dash with vinyl.
|
|
428street
Wed March 11, 2009 10:51am
Rating: 10
|
|
DocDirk
Sat April 25, 2009 1:13pm
|
Shaved Filter base and Tranny vacuum outlet
Shaved the filter base to tilt it under the scoop but the edges still hit and the mounting bolt won't work any longer of course.
|
|
cobbindale
Sun September 13, 2009 3:28am
Rating: 10
|
Paint protection
Clear protective paint film applied.
Barel visible line from mid headlight to mid leading edge of gaurd.
|
|
Wbulk
Fri May 7, 2010 11:44am
Rating: 10
|
Ball Joint Seal Ring
This is a Fix for A Arms that use the Chrystler ball joint without a seal groove machined in. This one was from B and B. A 3/16" steel ring was added to accept the ball joint seal. It was tack tig welded on the outside edges. The rings were cut on a water jet by Kirkhams Motorsports. Barry McGill can also do the fix.
|
|
wedgerton
Mon February 28, 2011 5:33am
|
Edgerton Cobra photos
Just finished with the build.
|
|
wedgerton
Mon February 28, 2011 5:33am
|
Edgerton Cobra photos
Just finished
|
|
wedgerton
Mon February 28, 2011 5:33am
Rating: 10
|
Edgerton Cobra photos
Just finished
|
|
wedgerton
Mon February 28, 2011 5:33am
Rating: 10
|
Edgerton Cobra photos
Just finished
|
|
frdfver
Mon December 2, 2013 8:04pm
|
NAF door sill Mod.
Modified the thin edge of the door sill from 1/8 out to 5/8.
|
|
cobrajeff
Wed January 1, 2014 8:49am
|
oil cooler scoop
the aluminum sheet I trimmed the scoop out with is held in place with silicones at the front edge and the cooler bolts on the back edge
|
|
52chevyred
Sun May 18, 2014 4:34pm
Rating: 10
|
Height of pipe edge to hinge leg
This side is 1". You will have to see what works for you.
|
|
52chevyred
Sun May 18, 2014 4:34pm
Rating: 10
|
Height of pipe edge to hinge leg fwd side
This side is 1 1/4"
|
|
grybrd123
Sun May 15, 2022 8:38am
|
Aceca colors and pattern
I plan to have the colors as on the sprayover dummy, blue and cream. The body will be cream and the area between the lines taped on the gold Aceca will be blue. Might have a dark blue pin stripe on the edge of the blue.
|
|
grybrd123
Sun May 15, 2022 8:38am
Rating: 10
|
Aceca colors and pattern
I plan to have the colors as on the sprayover dummy, blue and cream. The body will be cream and the area between the lines taped on the gold Aceca will be blue. Might have a dark blue pin stripe on the edge of the blue.
|
|
