AdamF
Sat August 13, 2011 9:33pm
|
Fuel tank
Here's the fuel tank with inbuilt pump etc.
|
|
AdamF
Sat August 13, 2011 9:36pm
|
Close up of brakelines
Here's a shot of the brakelines installed.
|
|
AdamF
Sat August 13, 2011 9:36pm
|
GForce Cobra with the 'lid' off.
Here's the Cobra after installation in my shed and the body off. Wasn't too hard as the bolts were all fairly obvious.
|
|
AdamF
Sat August 13, 2011 9:38pm
|
Picking her up from GForce
Here's what I was presented with when I went to pick up the car from Rob at GForce. Needless to say, you couldn't wipe the smile off my face.
|
|
AdamF
Sat August 13, 2011 9:42pm
|
Rear suspension
Here's a shot of the rear suspension.
|
|
AdamF
Sat August 13, 2011 9:42pm
|
Steering
Here's one of the steering.
|
|
nanard289
Fri December 30, 2011 1:35pm
Rating: 10
|
Building operation - second step
here I cut a 90° aluminum pipe elbow to have two small 40° elbow. This will allow to have a vertical 5° angle
|
|
MGlad
Thu May 31, 2012 5:56pm
|
MGlad 1
These are pictures from the ad that I found the Cobra. I haven't got it titled yet, I'm in NY... it's a long process here.
|
|
computerworks
Sun July 8, 2012 1:17pm
Rating: 10
|
CSX2459
Jim Hacker (pictured here) was a parner briefly of Bargelt's in purchasing CSX2459 in 1967
|
|
RallySnake
Thu October 25, 2012 10:15am
Rating: 10
|
Going for the zero.
Here we are appraoching a checkpoint timing hose at about 35 miles an hour and trying to get all four wheels to go across on the correct hundredth of a minute. We zeroed 6 of the 9 checkpoints on the Ace Ventura Rally.
|
|
justcobra
Sun January 6, 2013 7:40pm
|
RMC Series 3
Here is another view of the SAAS racing seats which were modified at great expense by previous matured aged Cobra owner and bought cheaply by myself.
These seats were legal at the time of the build according to the previous owner which I do not doubt.
To those that Modify Mazda MX5 seats here is another option if you operate on a budget.
I tried to fit MX5 seats into the RMC and they do not fit unless you modify the floor or tracks which defeats the whole purpose when you can pay upto $600 a pair.
|
|
GBowman
Thu January 31, 2013 3:24pm
|
Dyno427
Heres the Dyno sheet
|
|
52chevyred
Sun May 18, 2014 4:34pm
Rating: 10
|
Front of Hinge cut at 3/4"
Here is where the "original hinge" is cut, 3/4" inch, after the hinge pin. This is on the "front side", before the pipe is installed.
|
|
Bill E
Wed August 6, 2014 7:25pm
Rating: 10
|
GTO Not MY car but cool
New meteal coustoms Click here: New metal Kustomz
|
|
Gasdoc
Tue January 24, 2017 6:29am
|
Home at last.
Thought it would never get here !
|
|
