Nickpz1
Sun August 20, 2006 7:47am
Rating: 10
|
|
fastraxsg
Sun April 29, 2007 8:17pm
|
tow bar
Attaches to existing hole in middle of Torana front end, has welded vertical leg at rear to catch edge of crossmember. Drilled hole in front to attach clevis to.
|
|
Secret Squirrel
Mon October 29, 2007 2:48pm
Rating: 10
|
Drilled & Slotted Rotors
DRT Rotors BM02/BM05 installed with new longer wheel studs from Bimmerworld. PBR ULT Ceramic Pads D759/D754. Rotors and pads purchased from Vintage Motorsports. Upgrade Installed 4/25/2007
|
|
patrickt
Thu November 1, 2007 10:33am
Rating: 10
|
Clutch Fork Drilled for Easier Adjustment
Clutch Fork Drilled for Easier Adjustment
|
|
Shelboss
Mon January 28, 2008 5:34pm
|
Trunk Stay body mounting
Cobra Restorers Trunk Stay
Mounting holes drilled and tapped into support hoop
|
|
Baz
Thu April 17, 2008 8:45pm
|
Get out the hacksaw and drill.
The floor of the boot was removed today in readiness for the installation of the fuel tank. Rear lights were positioned and drilled as was the rear number plate light on the boot lid.
|
|
martrogers
Fri October 2, 2009 11:59pm
|
ackit
Pic showing the drilling template with 2 holes drilled. In the background is a template I made by putting cling film on the bonnet, and getting the curve into body filler. This mould template was then used to ensure the AC would fit the curve of the bonnet.
|
|
Wbulk
Mon December 7, 2009 5:10pm
Rating: 10
|
Gas Filler Modification
Modification to a B and B fuel filler. It is just setting in place. The LeMans cap still has to be drilled.
|
|
52chevyred
Fri January 1, 2010 6:51am
|
Body drilled for rollbar
Drilled for rollbar
|
|
52chevyred
Fri January 1, 2010 7:24am
|
Drilled for Rollbars
Package shelf drilled for rollbars
|
|
52chevyred
Fri January 1, 2010 7:24am
|
Package Shelf Drilled for rollbars
Package shelf drilled for rollbars
|
|
Excaliber
Tue May 4, 2010 12:08pm
Rating: 7.5
|
TKO-2
New clutch release arm had to be drilled out
|
|
Dimis
Sun December 2, 2012 2:07pm
Rating: 10
|
eightstack mainfold 3
Note small holes drilled out on the underside of each port for vacuum pressure referencing.
|
|
Earl J
Mon April 14, 2014 2:03pm
|
Return Spring and mounting bracket
I thought this was rather clever of me. That bracket curves around and clears the distributor body where I drilled and tapped a 10/31 heim joint for the dual return spring to connect. There is no binding on the return spring as well.
|
|
eschaider
Tue July 28, 2020 1:15am
Rating: 10
|
Winberg Billet Crank
Custom Billet crank w/SBC journals, long snout, big snout, crank snout stud anchored in #1 main, OEM oil pump drive removed and rifle drilled rod and main journals.
|
|
