n6opv
Thu January 22, 2009 11:23pm
|
Arntz tranny tunnel
Shown here is the removable section of the tranny tunnel. With the big engine setback in all the Arntz / Butler cars, you can remove the transmission while seated if you desire. Only a few very late Butlers had this and all Arntz Type 4 cars. I have no idea what the many cutouts are for  Also shown are the two triangulation tubes that connect the center of the cowl hoop to the 2 main frame rails for increased rigidity. The 3rd leg of the roll bar (not shown) also attaches to the same point on the passenger side frame rail. This is Arntz Type 4 only as well.
|
|
DocDirk
Sat April 25, 2009 1:59pm
|
Baffle tubes and packing from ClassicChambered
|
|
kitcarbp
Mon September 21, 2009 7:13am
Rating: 10
|
Griffin Rad for West Coast
Here is a top view of the Griffin 2 row rad 16 x 26 core size using 1.25" wide tubes.
|
|
Wbulk
Tue April 13, 2010 5:37pm
Rating: 10
|
Modified B and B Suspension Mounts
This was to correct a defect on some cars sold in 2009. The lower tubes were raised to the proper position in the picture. The upper mounts were redesigned and raised to accept a longer shock. This corrected bump steer, roll center and shock travel issues.
|
|
krausewich
Wed May 12, 2010 6:08am
Rating: 10
|
Cowl hoop and center brace tubes
Cowl hoop and center brace tubes
|
|
krausewich
Wed May 12, 2010 6:08am
|
Adding the hood jamb tubes and supportwork.
Adding the hood jamb tubes and supportwork.
|
|
Wbulk
Sat May 15, 2010 6:40am
Rating: 10
|
Full Roll Bar Home Built
2", .120 wall tubing designed to be chromed. You have to allow for chrome thickness where the tubes slid together. A lot more work than I thought. $175 invested so far. Bending and chrome brought the cost up to about $400.
|
|
Wbulk
Fri July 16, 2010 1:32pm
Rating: 10
|
Rear Bumper Modification
Completed modication with the welded on bracket on the end of the tubes cut off and bolts going through to the frame bracket.
|
|
krausewich
Sat July 17, 2010 8:26am
|
Side impact / occupant safety tubes added.
|
|
Tom Howland
Tue October 19, 2010 10:39pm
|
Right side header
SS 1 3/4 tubes
|
|
Tom Howland
Tue October 19, 2010 10:39pm
|
Right side header
SS 1 3/4 tubes
|
|
52chevyred
Wed September 28, 2011 3:02pm
Rating: 10
|
Lokar 302 dip stick top view
Had to "trim" the mounting bracket to fit between the header tubes, but worked out great!
|
|
MAStuart
Tue February 28, 2012 10:58pm
Rating: 10
|
|
Earl J
Tue October 22, 2013 11:03am
Rating: 10
|
48 IDA Emulsion tubes
My jet stack out of my Webers
|
|
DaveW
Thu February 20, 2014 5:30pm
Rating: 10
|
|
