Secret Squirrel
Tue December 21, 2004 7:56am
Rating: 10
|
Turn Signal Modification
Added 5/32 inch R/C Airplane wheel collar to canceling pin for improved operation, Dubro part #140, 12/18/2004.
|
|
427 S/O
Sun May 8, 2005 7:13am
Rating: 10
|
new CNC venturi
Reduced to 730 CFM from 1425 CFM, much better signal.
|
|
fastraxsg
Sat April 1, 2006 4:59am
Rating: 8
|
rear_end
Local made split manifold dumps into twin exhuast. Replaced original '68 VW tail lights with slightly better old style Ford teardrops, Honda marker lights for turn signals. License lamp goes back on after paint. Current Indonesian license plate good for 5 years at a crack. Due to age of car (1972) yearly registration is approx. $21. Number doesn't change, stays the same. Rear tires are Kumho 712's. Had to drop back to 235's as the wider tires rub on shock tower
|
|
Mike Simard
Wed May 24, 2006 1:54pm
Rating: 10
|
MANIFOLD9
Center area, vacuum manifold where the map sensor gets its signal
|
|
Scott S
Tue November 7, 2006 3:29pm
Rating: 10
|
Daytona Headlight
Daytona Coupe Headlight and signal
|
|
Randy Rosenberg
Mon July 16, 2007 1:22pm
|
Vacuum signal for Weber intakes...
|
|
patrickt
Thu October 30, 2008 1:36pm
|
|
rokndad
Thu March 18, 2010 9:30pm
|
|
Z-linkCobra
Thu July 22, 2010 7:40am
|
Converter box
This box will allow you to run a cable driven speedo off of the electronic sending unit in the new tannys. 3 wires out of the box 12vdc+ 12vdc- and signal from the sending unit off the tranny. Cable goes to the speedo.
|
|
289 Mk111
Fri March 9, 2012 6:34am
Rating: 10
|
not exact part but close
image 1
|
|
289 Mk111
Fri March 9, 2012 6:34am
Rating: 10
|
not exact part but close
image 1
|
|
289 Mk111
Sun April 29, 2012 11:53am
Rating: 10
|
Turn signal switch and Cowl
Mini Mk11 Turn, indicator switch and MGB Cowl assembled
|
|
Fox
Sat October 20, 2012 9:22am
|
Parts Collection
PL Lucas headlamps, filler cap, turn signal, kill switch, battery cables, Lucas 9H horns, L539 marker lamps, L542 tail lights
|
|
BT SNAKE
Thu April 17, 2014 6:44pm
Rating: 10
|
image196
This is a rear rectangle taillight assembly that I fabricated.
Inside the box is a metal separator to keep the bulbs from bleeding over the other. Those metal sockets were scavenged from a 70's car that had separate bulbs for brake and signal.
|
|
rodneym
Fri August 11, 2017 3:16pm
Rating: 10
|
billet turn signal cancel cam
I made a billet turn signal cancel cam from an old CNC slave cylinder. One more piece of billet for my KMP.
Yes, I was bored.
|
|
