fkemmerer
Thu May 14, 2009 6:59am
|
AFR1
Sample AFR table for an EFI FE. NOTE THAT NO ONE SHOULD COPY THIS TABLE AND JUST USE IT - THESE SETTINGS ARE NOT APPROPRIATE FOR EVERY MOTOR AND WHAT WORKS FINE IN MINE MAY VERY LIKELY DAMAGE YOURS.
|
|
fkemmerer
Thu May 28, 2009 6:05pm
|
Cranking Fuel Table for 482 ci FE with TWM Injections
Sample cranking fuel table table for an EFI FE. NOTE THAT NO ONE SHOULD COPY THIS TABLE AND JUST USE IT - THESE SETTINGS ARE NOT APPROPRIATE FOR EVERY MOTOR AND WHAT WORKS FINE IN MINE MAY VERY LIKELY DAMAGE YOURS.
|
|
Wbulk
Mon December 7, 2009 5:10pm
Rating: 10
|
Gas Filler Modification
Modification to a B and B fuel filler. It is just setting in place. The LeMans cap still has to be drilled.
|
|
Badvnm
Mon April 26, 2010 12:31pm
|
The First Ride
What a Rush, I was setting off the car alarms up
and down the street.
|
|
lal Naja
Wed June 2, 2010 9:50pm
|
Setting up the bell housing
Started with 0.027 inch misalignment
|
|
lal Naja
Wed June 2, 2010 9:50pm
|
Setting up the bell housing
Misalignment getting better
|
|
lal Naja
Wed June 2, 2010 9:53pm
|
Setting up the bell housing
This is as close as I can get it. Well within mfg's. specs.
|
|
Wbulk
Tue July 13, 2010 8:37pm
Rating: 10
|
Setting Pinion Angle
Checking pinion angel to adjust
|
|
Wbulk
Wed October 6, 2010 6:58am
Rating: 10
|
Setting on tires for the first time
Cobra setting on tires for the first time.
|
|
Wbulk
Sat March 26, 2011 5:35pm
|
Setting Wheelbase
Using a bar to measure off of to set wheelbase. Hold tape measure over half of K member thickness to get center of front spindle.
|
|
CobraMan2011
Sun July 31, 2011 8:03am
|
Joel's last build
first attempt at setting in the 473 big block to fab motor mounts, etc.
|
|
Rotax98
Sun January 15, 2012 4:09am
|
First Suspension Settings
|
|
Bitten Bob
Wed June 6, 2012 7:46am
Rating: 10
|
My new Superformance# 818,BB 514ci
My superformance, with car setting (HDR picture)
|
|
Wbulk
Tue April 23, 2013 7:44am
Rating: 10
|
Ford 9" Setting Carrier Bearing Preload
Ford 9" Setting the carrier bearing preload by spreading the case .010
|
|
gjkrv8
Sun July 20, 2014 8:05pm
|
|
