fastraxsg
Fri September 7, 2007 11:19pm
|
Old Girl's new coat
Taping up for another round of painting after 20 months in primer....
|
|
Shelboss
Mon January 28, 2008 5:34pm
|
Trunk Stay body mounting
Cobra Restorers Trunk Stay
Mounting holes drilled and tapped into support hoop
|
|
Pinoy2
Sun September 28, 2008 11:01pm
|
|
sganz
Tue December 23, 2008 9:00am
|
Motor Installed
This is a shot of the motor in the car with blue tape reminding me of the Chevy Firing order
|
|
Clois Harlan
Mon March 9, 2009 6:32pm
|
HCS Body side shot
Notice the outer skin of the door is still taped in place for final fitments and then the adhesive will be applied to make it one piece.
|
|
cobbindale
Wed April 29, 2009 10:02pm
Rating: 10
|
Stripes tapped
Stripes marked out
|
|
kitcarbp
Wed September 23, 2009 9:42am
Rating: 10
|
Cooling System Pressure Test Hose Connection
I tapped into the side of my expansion tank to check for potential cooling system leaks with 10-15 psi shop air.
|
|
martrogers
Fri October 2, 2009 11:59pm
|
ac4
Logo in position, just need to remove tape and fix from the underside (which means taking out radiator, draining down etc)
|
|
Z-linkCobra
Mon November 2, 2009 11:08am
|
Passanger side.
Try to seal your mold as best you can with duct tape you will get some leakage but not to worry...it comes off with a little effort from the prybar....lol.
|
|
Tom Kirkham
Mon November 30, 2009 10:06am
|
PV circuit mod
Tapping out the PV circuit for 6-32 set screws
|
|
Wbulk
Wed September 1, 2010 1:41pm
|
B and B Door Hinge Modification
By drilling out the hinge for tapered bolts this allows for the door panel to set flush with door. Extra piece of 1/8" steel added in the front for strength.
|
|
Wbulk
Sat March 26, 2011 5:35pm
|
Setting Wheelbase
Using a bar to measure off of to set wheelbase. Hold tape measure over half of K member thickness to get center of front spindle.
|
|
Earl J
Mon April 14, 2014 2:03pm
|
Return Spring and mounting bracket
I thought this was rather clever of me. That bracket curves around and clears the distributor body where I drilled and tapped a 10/31 heim joint for the dual return spring to connect. There is no binding on the return spring as well.
|
|
grybrd123
Sun May 15, 2022 8:38am
|
Aceca colors and pattern
I plan to have the colors as on the sprayover dummy, blue and cream. The body will be cream and the area between the lines taped on the gold Aceca will be blue. Might have a dark blue pin stripe on the edge of the blue.
|
|
grybrd123
Sun May 15, 2022 8:38am
Rating: 10
|
Aceca colors and pattern
I plan to have the colors as on the sprayover dummy, blue and cream. The body will be cream and the area between the lines taped on the gold Aceca will be blue. Might have a dark blue pin stripe on the edge of the blue.
|
|
