Morris
Fri December 8, 2006 6:44pm
|
|
scales
Sun December 2, 2007 12:31pm
Rating: 5.5
|
65_Mustang_rough_clone3_Medium_
The rear fender flare was removed to check out the work underneith. Lots of filler,fiberglass,and foam. The factory flare was cut out and the metal welded together. No rust, but enough damage to require new quarter panels.
|
|
TWOOD
Fri March 14, 2008 4:34pm
Rating: 10
|
door latch release linkage
View of lower end of linkage. Very much the same as drawing that Art Burtt has posted. Spring is secured to wheel well liner with a machine screw, short lenght of safety chain, a key ring. Light colored material behind the safety chain is insulating foam.
|
|
gjkrv8
Wed December 10, 2008 12:56pm
|
|
gjkrv8
Wed December 10, 2008 12:56pm
|
|
RJCCOBRA
Wed January 21, 2009 3:46pm
Rating: 1
|
Shell Valley build
The hood was bowed and warped so badly that we had to cut slots in the inner panel, fill with foam, and then add weight to level out the passenger's side. After the foam hardened, we put a layer of glass over the cuts and added weight again.
|
|
kitcarbp
Mon September 21, 2009 7:20am
Rating: 10
|
West Coast Griffin Rad Brackets
Here is a shot of my custom rad brackets made from 1/8 x 1.5" aluminum strip. Its a two peice design without welds and is adjustable to the core thickness. This core is 2.75" wide. I used High density EPDM sponge foam to line the inside of the bracket to absord vibration and protect the core frame.
|
|
Z-linkCobra
Mon November 2, 2009 11:08am
Rating: 1
|
Driver inner door
I poured and shaped the foam. Once I finish the passanger side and smooth the dash....then fiberglass work starts.
|
|
Z-linkCobra
Mon November 2, 2009 11:08am
|
Passanger side.
building the passanger side up with foam. You have to aware of the ambient temp. Anything below 80 and you dont get the expansion like you should. Takes alot more foam when its cooler.
|
|
Z-linkCobra
Mon November 2, 2009 11:08am
|
Dash and center console.
Once all the foam work is done and shaped...then all of it will get glassed in to the body. Making the dash, console and doors all one peice.
|
|
cobrajeff
Tue December 22, 2009 8:07am
Rating: 10
|
Heat shields added
I glued 3/4" foam insulation to the floorboards, and then sealed it off with sheet aluminium.
|
|
Austin_Snake
Wed March 20, 2013 3:27pm
Rating: 10
|
Ken Miles Seat Mounting
Cover removed showing original foam used.
Mount is getting attached.
|
|
Austin_Snake
Wed March 20, 2013 3:27pm
Rating: 10
|
Ken Miles Seat Foam
Adding additional Memory foam from Aircraft Spruce
|
|
Wazza
Thu January 28, 2016 7:31pm
|
Final heavy duty foam cover in wheel arch
|
|
kitcarbp
Tue August 1, 2023 5:39pm
|
Hard Top headliner
West coast hard top black foam headliner
|
|
