Thread: holes for door support rods
View Single Post
  #3 (permalink)  
Old 07-30-2011, 08:11 PM
Barnsnake's Avatar
Barnsnake Barnsnake is offline
Senior Club Cobra Member
Visit my Photo Gallery

 
Join Date: Nov 2003
Location: Parker County, Tx
Cobra Make, Engine: LoneStar LS427 , 427 Windsor
Posts: 381
Not Ranked     
Default
A Dremel tool with a small sanding drum works really well after you have the initial hole drilled. It cuts quickly enough with little risk of a big "oops".
__________________
Jim
------------
A Gnat! Quick, get a sledgehammer!
Reply With Quote