[ronzara]

Don,
Thanks for your reply.
I am using the CR push in dash lights.

I am also using a standard 3 position toggle for the Wipers. (unless something else is recommended). I am going to install a MG wiper assembly. The 14W I believe it is.

I think I can make the jumper harness for the dimmer switch. I guess I'd just need to attach 1 wire to #141 on the main harness and run it to the POWER on the Dimmer????

Then #143 Attaches to the HI-BEAM prong of the dimmer and #145 to the Low Beam Prong.... IS THIS CORRECT?


My fan has no name on it. But It is already wired to a switch, So, really, I guess, I just need power from the harness to the switch , .....there's NO thermostat.

On my Fuel gauge there are the letters G (obviously #190 GROUND) S (what # is attached) and an I (what # is attached) ?

TACHOMETER GND (#190) Bat (is this #130?) SIG (# ??)

Thanks.