View Single Post
  #3 (permalink)  
Old 07-01-2020, 04:21 AM
133bus 133bus is offline
CC Member
Visit my Photo Gallery

 
Join Date: Jun 2007
Cobra Make, Engine: dd cobra,351w mild cam
Posts: 119
Not Ranked     
Default

My roll bar is made of stainless steel..1 1/2" by 0.20 thick...I removed mine and took measurements and made up drawing with those dimensions and had a company that only works with tube and pipe make two mandrel bent roll bars...I was only going to have one made but decided to have two made instead just in case the one they made didn't match...I had to buy a whole length of tubing anyway and was able to get two made out of one length...They didn't put the brace on for me..just cut them two length and all out of the same length of tube..I had them shipped to my door and all in they cost me around 250.00 for two stainless steel roll bars..I made my own short stub tube to have welded onto the roll bar and had a local welder weld it on for me..I cut the straight length supplied to the right length...cut the holes in the body myself..welded in pickup points and you would think it came like that..and I have a spare hanging on the wall...steve
Reply With Quote