Rear braced roll bar

[133bus]

My roll bar is made of stainless steel..1 1/2" by 0.20 thick...I removed mine and took measurements and made up drawing with those dimensions and had a company that only works with tube and pipe make two mandrel bent roll bars...I was only going to have one made but decided to have two made instead just in case the one they made didn't match...I had to buy a whole length of tubing anyway and was able to get two made out of one length...They didn't put the brace on for me..just cut them two length and all out of the same length of tube..I had them shipped to my door and all in they cost me around 250.00 for two stainless steel roll bars..I made my own short stub tube to have welded onto the roll bar and had a local welder weld it on for me..I cut the straight length supplied to the right length...cut the holes in the body myself..welded in pickup points and you would think it came like that..and I have a spare hanging on the wall...steve

[1985 CCX]

I would call John Bessey, think he has the bender and could duplicate.
You may want to make two so they are a match or send him yours and have it duplicated.
He is in CA

email/text me and I'll get you his #