View Single Post
  #9 (permalink)  
Old 11-21-2021, 07:29 PM
RonKahn RonKahn is offline
CC Member
Visit my Photo Gallery

 
Join Date: Jul 2021
Location: Denver, NC
Cobra Make, Engine: Classic Roadsters, 347 stroker
Posts: 43
Not Ranked     
Default

Quote:
Originally Posted by sunman View Post
The SN95 axels are 1 1/2 wider total. Up to 98 used same housing. Your axels stick out more.
Put your wheels on to measure track width, its the wheel center
I dont have wheels yet, still have to purchase them. Right now, I just have some old Mustang factory wheels on them for now so to mock up everything. I was going to purchase rims and tires later, assuming I can get specific wheel offset/backspacing for each axle for my needs. I cant go wider in the front as it is factory width and a MustangII front end. You may be right, I have a wider rear end, which may cause me to not have as deep of a dish wheel. That will be unfortunate, but it is what it is right now. Not going to find another rear end and start over. Nor am I going to narrow this rear end.
Reply With Quote