11-21-2021, 07:29 PM
|
|
CC Member
|
|
|
Join Date: Jul 2021
Location: Denver,
NC
Cobra Make, Engine: Classic Roadsters, 347 stroker
Posts: 116
|
|
Not Ranked
Quote:
Originally Posted by sunman
The SN95 axels are 1 1/2” wider total. Up to 98 used same housing. Your axels stick out more.
Put your wheels on to measure track width, it’s the wheel center
|
I dont have wheels yet, still have to purchase them. Right now, I just have some old Mustang factory wheels on them for now so to mock up everything. I was going to purchase rims and tires later, assuming I can get specific wheel offset/backspacing for each axle for my needs. I cant go wider in the front as it is factory width and a MustangII front end. You may be right, I have a wider rear end, which may cause me to not have as deep of a dish wheel. That will be unfortunate, but it is what it is right now. Not going to find another rear end and start over. Nor am I going to narrow this rear end. |
4Likes
Threaded Mode
