09-09-2010, 07:59 PM
|
 |
CC Member
|
|
|
Join Date: Jun 2004
Location: Potomac,
MD
Cobra Make, Engine: West Coast, 460 Ford Racing Crate w/ TREMEC TKO 600
Posts: 732
|
|
Not Ranked
Jeri, thanks I found them on their web site. I am looking for the neck that has the threaded boss in the top where I mount an air bleed-off valve to make system filling easier. The NOS part runs for $80+ on flea bay. I may find a used OEM one and clean it and paint it.
This threaded boss was used for a vac switch back in the 70's. I'm using a ACCEL dist (DURASPARK) from Ford racing and clearance to the housing is not an issue for me. Tonight I measured the flange face warpage on the chrome Transdapt/Mr Gasket/Ford Racing neck. I have a new one to compare it to, and the leaking one with about 10 hours running time on it has a warped of 0.015" which was the cause of the leak. I have heard folks will mill or grind it flat again but it warps again after a while. 
__________________
"...some assembly required, ages 8 and up...... well that took longer than expected......
|
Threaded Mode
