03-15-2018, 12:15 PM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Mar 2000
Location: St. Augustine,
FL
Cobra Make, Engine: E-M / Power Performance / 521 stroker / Holley HP EFI
Posts: 1,935
|
|
Not Ranked
last,
According to the Edelbrock site here: Intake Manifolds - Ford - Big-Block - Torker II Series - Edelbrock, LLC.
the lowest manifold they make is the Torker II, and it Their quoted port size is 1.75" x 2.1". If you decide to use it you can do a port match - I think I recall there's enough material there for doing that.
I use this manifold and its EFI twin on two 385s, each much larger than 460 and they run just fine!
Hope this helps,
Tom
__________________
Wells's law of engine size: If it matters what gear you're in, the engine's too small!
|
Hybrid Mode
