Thread: If you're fighting Weber Gremlins...check this out concerning linkages
View Single Post
  #5 (permalink)  
Old 07-23-2004, 07:44 AM
DonC's Avatar
DonC DonC is offline
Senior Club Cobra Member
Visit my Photo Gallery

 
Join Date: Jun 2003
Location: West Linn, OR
Cobra Make, Engine: ERA #684, 428 FE, TKO600
Posts: 1,378
Not Ranked     
Default
Just my opinion but I'd want the throttles to be pulled open rather than pushed. Also might change the position of the bell crank a bit forward. Looks like the onside linkage is at a greater angle than the off side. Also try to "balance" or center the amount of pivot that the bell crank has to make so it's even from stop to wot.
Just thoughts.
DonC
Reply With Quote