Thread: Knock Off Wheel Question
View Single Post
  #4 (permalink)  
Old 11-23-2004, 05:16 AM
351-EM's Avatar
351-EM 351-EM is offline
CC Member
Visit my Photo Gallery

 
Join Date: Oct 2003
Location: Virginia Beach, VA
Cobra Make, Engine: Everrett-Morrison Cobra, 427W T-5 Z tranny
Posts: 130
Not Ranked     
Default
Hi,

Thanks for the responses. It is a solid axle and the overall width of my 9" ford rear is just under 53" axle tube face to axle tube face. I have a set of American racing Torque Thrust D's that were on the previous rear, which was 54.4" axe tube face to axle tube face. The rear rims have roughly 6.5" of backspacing and a width of 11".
I am planning to mount them on each rear to determine the overall width to make an assessment before I proceed further. I simply thought that I would ask to see if there was anyone out there who may have encountered a similar problem during their build. If there is any narrowing needed I would certainly like to get it done now vice later.

Thanks,

Chris
Reply With Quote