Quote:
Originally posted by Fred Hamilton
Jake
The motor is being sent to Tom at Fe Specialties for a complete tear down and he will start with a whole new bottom end and use all the bolt ons from my old "Y" Block. Might even have a few goodies added while its there.
Fred & Brenda
|
Tom builds one hella-fine motor based on a Y block. He can also 'trick' it out pretty good!
Check my photo gallery for some of Tom's handiwork!
66' 427fe side oiler, bored & stroked to 474ci. Alum. heads w/stage III port job, roller cam, Erson roller rockers, 850 Demon carb on a Edelbrock RPM Performer intake manifold, Aviaid
oil pan. 10.2 compression, runs on pump gas. Balanced & Blueprinted 600hp/600tq!
jdog
P.S. You can also see it on Tom's web page, or at his shop, where it waits for my car to be delivered!
