07-30-2005, 10:02 PM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Feb 2004
Location: Sacramento,
CA
Cobra Make, Engine: Shelby CSX4795 (Sold)
Posts: 1,542
|
|
Not Ranked
FE Specialties
Quote:
Originally posted by Fred Hamilton
Jake
The motor is being sent to Tom at Fe Specialties for a complete tear down and he will start with a whole new bottom end and use all the bolt ons from my old "Y" Block. Might even have a few goodies added while its there.
Fred & Brenda
|
Tom builds one hella-fine motor based on a Y block. He can also 'trick' it out pretty good!
Check my photo gallery for some of Tom's handiwork!
66' 427fe side oiler, bored & stroked to 474ci. Alum. heads w/stage III port job, roller cam, Erson roller rockers, 850 Demon carb on a Edelbrock RPM Performer intake manifold, Aviaid oil pan. 10.2 compression, runs on pump gas. Balanced & Blueprinted 600hp/600tq! 
jdog
P.S. You can also see it on Tom's web page, or at his shop, where it waits for my car to be delivered! 
__________________
"If you can't run with the BIG DOGS, stay under the porch!"
|
Threaded Mode
