1.5 inch rollbar bezels

ndpace · #1 (**permalink**) 02-23-2010, 12:45 PM

does anyone know where I can puchase 1.5 inch rollbar bezels that have the oval shape for the rear support bar?
Finishline says they only have them with the oval for the 2 inch bars.

Thanks, Jim

Bernica · #2 (**permalink**) 02-23-2010, 01:18 PM

Good luck with that one! I used the Finishline 1-1/2" ones and got it to work fine. The rear one can be tough, but it will work. See pic in my gallery.

ndpace · #3 (**permalink**) 02-23-2010, 01:45 PM

can you tell me the outer diameter of the bezels? I want to make sure it will cover the hole already in the fibeglass. I dont want to buy 2 sets and have them not work.

Thanks, Jim

mickmate · #4 (**permalink**) 02-23-2010, 03:25 PM

3.375" they need some persuading but can be made to work on the rear brace.

Bernica · #5 (**permalink**) 02-23-2010, 04:22 PM

The one I have measures as follows:

Outside of rubber grommet = 3-3/8"
Outside of chrome ring = 2-7/8"
Inside of chrome ring = 2-3/8"

Bernica · #6 (**permalink**) 02-23-2010, 04:27 PM

Sorry, correction:
INSIDE of chrome ring = 2-1/4"
I measured one of the standard ones instead of the one on eh rear that needed the "massage".

jwd · #7 (**permalink**) 02-23-2010, 04:40 PM

Russ made mine - http://www.norcal-cobras.com/store/r...uss_garage.htm

If he doesn't have a template for your application, you can send him one and he'll make them for you. Mine is 1 1/2" and the rear is oval. They came out perfect. I highly recommend him. He's done several for us Hurricane folks.

Jim

Bernica · #8 (**permalink**) 02-23-2010, 05:10 PM

Those are some beautys! Wish I'd found them before now. Maybe when I run out of things to do.....yea, right.