Please check my wiring....thanks

[dlotz]

Just checking to see if this is correct. Let m eknow if you guys see anything wrong.

I forgot to draw in the Remote selonoid and the voltage regulator casings are grounded to the block along with the MSD.

Thanks

[dlotz]

Anyone out there?

[PANAVIA]

D -- Greetings, some notes ;

1. There should not be a wire between the Dist and the coils --

2. In an MSD setup the only wires attached the coil leads should be from the MSD.

3. The TACH lead in the MSD should be grey I thought.

4. I cannot see the detail of where and how your *A* terminal is wired from the VR to the rest of the system.

5. the *I* terminal on the starter solenoid can be used to feed things as it is just a "Lug" for 18-22 gauge wire.

you can have an ignition relay feed the I terminal and use it to feed things like electric chokes, MSD switched on leads, or >?

a larger drawing with the relays and their connections outlined would be helpful!

hope this helps.

Steve

[dlotz]

Originally Posted by PANAVIA

D -- Greetings, some notes ;

1. There should not be a wire between the Dist and the coils --

2. In an MSD setup the only wires attached the coil leads should be from the MSD.
Steve

That is the Plug wire that I am showing.

[PANAVIA]

ahhhh -- didnt see that detail.

[dlotz]

I am getting a few post about the ALT wire needing to be on the other post of the kill switch. They are saying that it needs to be on the battery feed side.