Working on Keith Craft open house

[Bernica]

Sounds like a great idea! I think I would like to make the trip. I assume I would fly into Little Rock?
I'll watch this thread for when you nail down the date.

[DanEC]

I sent out feelers to some of the local shops and car clubs. Only heard back from one of the Corvette guys so far but he sounded very interested and knowing him, I suspect he could get a group down there. There's a number of Ford guys up here that should be interested. I think seeing a dyno in operation, some of the CNC equipment in operation and end products would be interesting. A lot of people just like to wander around and look at the assembled engines and old parts and a few interesting cars. When I was down there a few weeks ago watching my motor run, you had a number or unique engines in there that were interesting to look over - restoration Cobra Jets, old Ram Hemi, couple Chev motors, I think I remember a Cadillac motor. And then the stroker SOHC motor.

If you have enough room outside you might sponsor a swap meet as part of it.

[Seagull81]

I hope you aren't going to skip the Texas Cobra Meet at the end of March!