11-24-2010, 06:08 AM
|
 |
CC Member
|
|
|
Join Date: Apr 2010
Location: Tampa,
FL
Cobra Make, Engine: Everett Morrison
Posts: 144
|
|
Not Ranked
As always, I'm very thankful for the support here on CC!
I have been very satisfied with the performance of the motor so far. It does provides plenty of power for the occasional 1/8 mile and Auto X runs, however, when I do decide to make some changes, I'd like to be sure I know more about the foundation.
I plan to swap out the Offy 2X4 intake for a single four and get rid of the 2 Edlebrocks all together. I haven't ever been satisfied with the setup. My dyno curve shows both torque and horsepower coming in too high in the RPM range in my opinion. I'd like to see a more "street" friendly curve if possible.
Also, if the 428 provides more low end torque, I'd like to take advantage of it. My last chasis dyno shows 356 ft/lbs, seemed low.
Again, thanks for all of the support!
Mike
|
Threaded Mode
