Pilot Bearing Question

[Rawkkrawler]

I've read the previous threads on this topic but still can't seem to find my answer.

My current roller pilot bearing is bad in my FE 428. I pulled it out and measured the following:

OD - 1.25"
ID - .669" (Tremmec 3550)
Depth - .75"

I also noticed that there is an outer recess that measures roughly 1.83". So my guess is that two different OD bearings can be used? Providing of course that I get my .669" ID.

To keep it simple, I'd prefer to replace what I pulled out, but it seems harder than I expected.

Any suggestions?