12-23-2014, 05:01 PM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Apr 2007
Location: ione,
ca
Cobra Make, Engine: SPF #1473 392 cu.in. titanium/black stripes
Posts: 945
|
|
Not Ranked
Huzzah, Huzzah! Frankym, you are the Man!
How difficult was it to bend the Cobra Restorers down bar to fit the original mounting point on the right side of your SPF? How about posting some photos of the mounting points of both ends of the rollbar, the one between the seats and the one behind the rear wheel.
As you complete this project and reflect on what you have done, do you have any thoughts about what you might change if you were going to start over and do it again?
Thanks for any ideas you may have.
Bob
__________________
"Outside of a dog, a book is man's best friend. Inside a dog it's too dark to read."
Groucho Marx
|
20Likes
Threaded Mode
